Loading ...
Loading ...
Loading ...
7
operating.
•
Disengage all control levers and stop engine before you leave the operating.
•
Wait until the auger /impeller comes to a complete stop before unclogging the chute assembly,
making any adjustments, or inspections.
•
Never put your hand in the discharge or collector openings. Always use the clean-out tool provided to
unclog the discharge opening. Do not unclog chute assembly while engine is running. Shut off engine
and remain behind handles until all moving parts have stopped before unclogging.
•
Use only attachments and accessories approved by the manufacturer.
•
When staring engine, pull cord slowly until resistance is felt, then pull rapidly, Rapid retraction of
starter cord (kickback) will pull hand and arm toward engine faster then you can let go. Broken bones,
fractures, bruises or sprains could result.
•
If situations occur which are not covered in this manual, use care and good judgment contact
customer support for assistance.
MAINTENANCE & STORAGE
•
Never tamper with safety devices. Check their proper operation regularly. Refer to the maintenance
and adjustment sections of manual.
•
Before cleaning, repairing, or inspecting machine disengage all control levers and stop the engine.
•
Wait until the auger impeller comes to a complete stop. Disconnect the spark plug wire to prevent
unintended starting.
•
Check bolts and screws for proper tightness at frequent intervals to keep the machine in safe working
condition. Also, visually inspect machine for any damage.
•
Do not change the engine governor setting or overspeed the engine. The governor controls the
maximum safe operating speed of the engine.
•
Snow thrower shave plates and skid shoes are subject to wear and damage. For your safety protection,
frequently check all components and replace with original equipment manufacturers (OEM) parts
only. Use of parts which do not meet the original equipment specifications may lead to improper
performance and compromise safety.
•
Check control levels periodically to verify they engage and disengage properly and adjust, if
necessary. Refer to the adjustment section in this operator's manual for instructions.
•
Maintain or replace safety and instruction labels, as necessary.
•
Observe proper disposal laws and regulations for gas, oil, etc. to protect the environment.
•
Prior to storing, run machine a few minutes to clear snow from machine and prevent freeze up of
auger impeller.
•
Never store the machine or fuel container inside where there is an open flame, spark or pilot light
such as water heater, furnace, clothes dryer etc.
•
Always refer to the operator's manual for proper instructions on off-season storage.
•
Check fuel line, tank, cap and fittings frequently for cracks or leaks. Replace if necessary.
•
Do not crank engine with spark plug removed.
•
Have the machine inspected annually by an authorized service dealer to ensure that all mechanical
and safety systems are working properly and do not worn excessively. Failure to do so can result in
accidents, injuries or death
DO NOT MODIFY THE ENGINE
To avoid serious injury or death, do not modify engine in any way. Tampering with the governor setting
can lead to a runaway engine and cause it to operate at unsafe speeds. Never tamper with factory setting
of engine governor.
Loading ...
Loading ...
Loading ...