Loading ...
Loading ...
Loading ...
2N TELEKOMUNIKACE a.s., www.2n.cz 173/233
Tip
Wiring diagram of IN1 connector in active mode
Wiring diagram of IN1 connector in passive mode
LTE Connection Verification
Having connected the power supply, make sure that has been 2N LTE Verso
®
connected to the LTE data network successfully. A red LED (R) located to the left of
the BUS connector on the upper board provides basic diagnostics: flashing means
connecting, if the LED goes off, the device is connected to the data network. If it is
illuminated for 5 seconds, there is a SIM card error (SIM not inserted, PIN request
When this 5s timeout is over, another connection enable or no active data service).
attempt is made and the LED starts flashing again, i.e. the LED does not shine
permanently if there is a problem. If it keeps flashing only, the LTE signal is insufficient.
In this case, check the area LTE signal coverage and antenna connection. If the LTE
signal is low, use an appropriately placed external antenna (optional accessory, Part
No. 9155048). Caution – do not stick the external antenna to a metal surface!
You can also use the diagnostic SMS commands described in for 3.1 Configuration
troubleshooting.
Reset Button
Located among the main unit connectors, the Reset button helps you reset the factory
default values and restart the device.
Factory Reset
Loading ...
Loading ...
Loading ...