Loading ...
Loading ...
Loading ...
INSTRUCTION SHEET
©2021 Electrolux Home Products, Inc. Instruction Sheet A00343905 7.23.21
Instructions for Single Installation Trim Kits:
TRMKTEZ1FL79 (Frigidaire)
TRMKTSS1LV84 (Electrolux)
Leveling System Installation
1. a. Lay the unit on its back
on packing material or
a drop cloth to prevent
damage.
b. Remove both rear leg
levelers by unscrewing
counterclockwise (Fig. 1A),
and store them with
your Product Literature.
c. Remove both front leg
levelers by unscrewing
the outer peg and 2
bolts on each front
leveler with a
5
/
16
” nut
driver. Remove the hinge
cover if it is installed
(Fig 1B), and store them
with your Product Literature.
2. Lay the parts out on a
cleared area face down. Be
sure to place a drop cloth
over the floor to prevent
scratching the trim kit and/or
floor (Fig. 2).
Fig. 1
A B
Fig. 2
3. a. Fit the first Leveler
Assembly onto
a refrigerator/freezer
(Fig. 3).
b. Using a 5H bolt and
a power drill, fasten the
bottom of the Leveler
Assembly with a
3
/
8
”
hex drill bit in whichever
hole overlaps the screw
hole (Fig. 4).
Fig. 3
Fig. 5
c Using the 4H bolts from
step 1, fasten the front of
the Leveler Assembly to
the refrigerator/freezer
using a
5
/
16
” nut driver
(Fig. 5). If more fastening
space is required, rotate
the bolt labeled F
clockwise (Fig. 6) using a
flathead screwdriver or a
3
/
8
” socket wrench.
Fig. 6
d. Attach the remaining
Leveler Assembly as
described in the previous
3 steps. With the unit still
on its back, adjust
all leveling wheels to
approximately the
orientation in Fig. 7.
Fig. 4
Fig. 7
Leveling the Unit
4. a. Tilt the unit upright.
b. Place the unit into the
cabinet space, or as
close to the final position
as possible (do not hook
up power or water yet).
This step is important to
accurately level the unit
prior to further installs.
c. Use a flat head screw
Fig. 8
NOTE
Some cabinet substrates may require pre-drilling holes using a
1
/
8
”
(3 mm) diameter drill bit.
driver or a
3
/
8
” socket wrench to adjust the front bolts of
the Leveler Assemblies (Fig. 8). Raise or lower the front
and back wheels as needed until the unit rests properly in the
cabinet space.
d. Once the Leveler Assemblies have been checked, roll out
the unit in front of the cabinetry for accessibility.
Electrolux TRMKTSS1LV84 Side Trim Attachment Setup
5. Using eight 3H screws and
a power drill, attach the
2 Side Trim Attachment
brackets to the front left and
right cabinet cutout edges
with the brackets touching
the floor (Fig. 9). Ensure the
rectangular slots extend over
the cabinet edge.
Fig. 8
Loading ...
Loading ...