Loading ...
Loading ...
Loading ...
2.2 Installation of Type II Camera
2.2.1 Ceiling/Wall Mounting Without Junction Box
Steps:
1. Paste the drill template on the wall/ceiling.
2. (Optional) For cement wall, drill the screw holes
with a 5.5 mm drill and insert the supplied wall
plugs.
3. Drill the screw holes and the cable hole (optional)
on the ceiling.
4. Route the cables through the cable hole, or the side
opening.
5. Attach the bracket to the ceiling, and secure the
camera with three PA4 × 25 screws (supplied).
Figure 2-10 Install Camera to Ceiling
6. Connect the cables.
7. Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, loosen the trim ring to adjust the position.
Rotation Position
[0° to 360°]
Pan Position
[0° to 360°]
Tilt Position [0° to 90°]
T
R
P
Figure 2-11 3-Axis Adjustment
1). Loosen the T adjusting screw to adjust the tilt
position [0° to 90°].
2). Loosen the P adjusting screw to adjust the pan
position [0° to 360°].
3). Loosen the R adjusting screw to adjust the
rotation position [0° to 360°].
8. Tighten the screws to finish the installation.
2.2.2 Ceiling/Wall Mounting with Junction Box
Before you start:
You need to purchase a junction box in advance.
Ceiling mounting and wall mounting are similar.
Following steps take wall mounting as an example.
Steps:
1. Paste the drill template on the ceiling/wall.
2. (Optional) For cement wall, drill the screw holes
with a 5.5 mm drill and insert the supplied wall
plugs.
3. (Optional) Drill the cable hole, when the cables are
routed through the wall.
4. Take apart the junction box, and align the screw
holes of the camera with those on the junction
box’s cover.
5. Attach the camera on the junction box’s cover with
three PM4 × 10 screws.
Loading ...
Loading ...
Loading ...