Loading ...
Loading ...
Loading ...
8
INSTALLATION
Leveling Freezer Drawer (if necessary)
1. Check gasket seal around top, bottom, and sides of
freezer drawer.
2. If gasket is not sealed, open drawer and slightly loosen
four drawer screws (two on each side) to allow drawer
to rotate (see illustration).
3. Close drawer and recheck the seal on the gasket (A).
Open the drawer grabbing by the sides in the center
(B). Be careful not to rotate the drawer.
Remove hex
head drawer
screw
Remove hex
head drawer
screw
Remove hex
head drawer
screw
Remove hex
head drawer
screw
Do not remove
other screws
4. Tighten four drawer screws.
5. Recheck gasket seal.
Push
against
freezer
drawer
Grab
drawer
at center
from both
sides
then
pull
drawer
out
A
B
Level Refrigerator & Adjust Doors (if neces-
sary)
Guidelines for nal positioning of your refrigerator:
• All four corners of the cabinet must rest rmly on the
oor.
• The sides should tilt ¼ inch (6 mm) from front to back
(to ensure that doors close and seal properly).
• Doors should align with each other and be level.
Most of these conditions can be met by raising or low-
ering the adjustable front rollers.
To level the cabinet using the front rollers:
1. Slightly open freezer drawer.
2. Remove the toe grille. See Figure 13.
Figure 13: Remove screws and then gently pull forward.
Remove
mounting
screws
3. You can raise or lower each door. Use a ⅜ inch socket
wrench to turn the adjustment screws (one per side).
To raise: turn adjustment screw clockwise.
To lower: turn adjustment screw counterclockwise.
4. Ensure both doors are bind-free with their seals touch-
ing the cabinet on all four sides and that cabinet is
stable.
5. After unit is leveled, lower anti-tip leg until it contacts
the oor.
6. Install the toe grille by tting into place (replacing
screws on some models).
Door Door
Anti-tip
leg
Raise
Lower
Figure 11
Figure 12
Figure 13
Figure 14
Loading ...
Loading ...
Loading ...