Loading ...
Loading ...
Loading ...
● If using a funnel, make sure it is plastic and has no
screen or lter.
1. Park machine safely. (See Parking Safely in the Safety section.)
2. Allow engine to cool.
3. Remove any debris from area around fuel tank cap.
4. Remove fuel tank cap slowly to allow any pressure built up in tank
to escape.
5. Fill fuel tank only to bottom of ller neck. Do not overll.
NOTE: On some models, the fuel tank cap will click when it is tight.
6. Install fuel tank cap and turn cap until it is tight.
MP47322,00F4675-19-24AUG21
Lifting Machine
1. Park machine safely. (See Parking Safely in the Safety section.)
CAUTION: Avoid injury! The machine can fall or slip from an
unsafe lifting device or supports.
● Use a safe lifting device rated for the load to be lifted.
● Lower machine onto jackstands or other stable supports
and block wheels before servicing.
NOTE: Remove any material collection system attachments prior to
lifting machine.
APY74530—UN—07JUN22
2. Safely lift rear of machine frame points (A). Place jackstands or
other stable supports onto transaxle locations (B).
GX536028—UN—25APR22
3. Safely lift front of machine at machine frame points (C). Place
jackstands or other stable supports onto machine frame locations
(D).
4. If lifting only the front of machine, block rear wheels remaining on
ground to avoid movement of machine.
5. To lower the machine, lift front and/or rear of machine, and remove
jackstands or supports. Lower the machine.
H9PQBYK,0000062-19-13JUN22
Checking Tire Pressure
CAUTION: Avoid injury! Explosive separation of tire and rim
parts is possible when they are serviced incorrectly:
● Do not attempt to mount a tire without the proper
equipment and experience to perform the job.
● Make sure that all tires are inated to the recommended
pressure, especially when operating on slopes. Low
pressure can cause machine to become unstable on
slopes.
● Do not weld or heat a wheel and tire assembly. Heat can
cause an increase in air pressure resulting in an
explosion. Welding can structurally weaken or deform
the wheel.
● Do not stand in front or over the tire assembly when
inating. Use a clip-on chuck and extension hose long
enough to allow you to stand to one side.
1. Check tires for damage.
2. Check tire pressure with an accurate low-pressure gauge.
3. A lower pressure will improve traction and performance depending
on turf conditions or if transport areas have steep inclines.
4. Add or remove air to meet specied tire pressure. (See
Specications section for recommended tire pressures.)
MP47322,00F4677-19-10JUN20
Removing and Installing Wheel Assembly
Removing
1. Park machine safely. (See Parking Safely in the Safety section.)
CAUTION: Avoid injury! The machine can fall or slip from an
unsafe lifting device or supports.
● Use a safe lifting device rated for the load to be lifted.
● Lower machine onto jack stands or other stable supports
and block wheels before servicing.
Service Miscellaneous
47
Loading ...
Loading ...
Loading ...