Loading ...
Loading ...
Loading ...
Publication date: Jul., 2016
Revision A1
9
2-2 IP Address
2-2.1 IP Settings
IPv4 DHCP Enable:
Enables the DHCP client mode setting for listening to a DHCP server in the local network.
IPv4 Address:
The IPv4 address of the interface VLAN1.
Subnet mask:
The IPv4 network mask of the interface VLAN1.
DNS Server:
Select the source of DNS service.
1. No DNS server.
2. Configured: User defined.
3. From any DHCP interfaces: as provided by a router offering the DHCP service
4. From this DHCP interface: If a router exists in a specific VLAN configuration, listen
to the particular router for the DNS service.
Figure 2-2.1: IP Settings
2-2.2 Advanced IP Settings
The IPv4 address for the switch could be obtained via DHCP Server for VLAN 1. To manually
configure an address, you need to change the switch's default settings to values that are
compatible with your network. You may also need to establish a default gateway between the
switch and management stations that exist on another network segment.
Configure the switch-managed IP information on this page
Configure IP basic settings, control IP interfaces and IP routes.
The maximum number of interfaces supported is 8 and the maximum number of routes is 8.
Web Interface
To configure an IP configuration in the web interface:
1. Click System, IP Advance and IP Configuration.
2. Click Add Interface then you can create new Interface on the switch.
3. Click Add Route then you can create new Route on the switch
4. Click Apply
Loading ...
Loading ...
Loading ...