Loading ...
Loading ...
Loading ...
73
5 - once the adjustment has been made, re-seal the seals on
the by-pass with sealing wax or equivalent materials
In the case of liquid gases (e.g. LPG), the adjustment screw
must be screwed in completely.
Warning! At the end of the operation, replace the old
calibration label with the one for the new gas used.
Warning! If the pressure of the gas used is different (or
variable) from that the one indicated, an appropriate pressure
regulator on the inlet pipe must be installed that complies with
the national standards in force.
The amount of air required for combustion must not be
less than 2.0 m3/h for each kW of installed power.
See the table for the burner power.
3.3 Mounting
Before starting the installation:
• After unpacking the product, check that it has not been
damaged during transport and in the case of problems,
contact your dealer or Customer Service, before
proceeding with the installation.
• Check that the product is the right size for the installation
location.
• Check for accessories inside the packaging (placed there
for ease of transport) such as bags containing screws,
the warranty card, etc.. Remove them and keep them
safe.
• Also check that there is a power socket near the
installation area
Preparing the cabinet for installation:
- The product cannot be installed above cooling appliances,
dishwashers, heaters, ovens, washing machines and
dryers.
- Cut the cabinet before inserting the hob and carefully
remove shavings or sawdust.
IMPORTANT: use a single component adhesive sealant
(S), resistant against high temperatures up to 250°;
prior to installation, the surfaces that need to be glued
must be carefully cleaned, removing all substances that
may compromise adhesion
(e.g. release agents, preservatives, grease, oils, powders,
old adhesive residue, etc.);
the sealant must be evenly distributed along the entire
perimeter of the frame;
after gluing, leave to dry for approximately 24 hours.
Fig. 1b
CAUTION! Failure to install screws and fasteners in
accordance with these instructions may result in electrical
hazards.
Note: to ensure the correct installation of the product, it is
recommended to tape the pipes using an adhesive with the
following characteristics:
- soft elastic PVC film, with an acrylic-based adhesive
- which complies with DIN EN 60454 regulations
- self-extinguishing
- excellent resistance against wear
- resistant against temperature fluctuations
- can be used in low temperatures
Loading ...
Loading ...
Loading ...