Loading ...
Loading ...
Loading ...
10
Notes:
• Do not use any cleaning head for floor drying.
• Do not touch the rotating part of the cleaning head.
To maintain optimal performance of the
product, refer to the following table for routine
maintenance.
Routine Maintenance
E
Take out the dirty tank, pull out the
cover, and open the water level sensors.
Clean the parts with the provided
maintenance brush, rinse them with
cold water, and then snap the water
level sensors back in place.
1. Remove the vacuum cleaner from the
Take out the filter from the dirty water
tank cover and remove any trash
attached to the filter. If the filter is dirty,
rinse it with cold water and then shake
off the residual water.
Rotate the rear roller cover to the
unlock position, and pull the rear roller
outward.
Pinch the left and right front rollers with
both hands, and pull them outward.
Allow up to 24 hours for all parts drying
and install them back in place.
E1
Cleaning the Dirty Tank
and Filter
E2
Cleaning the Rollers
E1-1—
E1-2—
E2-1—
E2-2—
E1-3—
Notes:
• Use a second filter if necessary.
• Do not touch the filter with your hands, brushes, or sharp
objects to avoid damage to the filter.
Parts
Maintenance
Frequency
Replacement
Frequency
Roller 2–4 weeks 6–12 months
Filter (dirty tank) 1 month 6–12 months
Filter (dustbin) 1 month 6–12 months
Cleaning head
and dirty water
pipe
1 month N/A
Dirty tank 1 month N/A
Dirty water level
sensor
1 month N/A
Charging dock
tray
As needed N/A
Charging
contacts
1 month N/A
Dustbin 1 month N/A
Multi-Surface
Brush
1 month N/A
Motorized
Mini-Brush
1 month N/A
Product Maintenance
Cleaning the Main Unit and Body
If this product is left unused for a prolonged
period of time, fully charge it and unplug it
before storing it in a cool and dry place. Do not
place the product in humid locations or under
direct sunlight. Charge it at least once every 3
months to avoid overdischarge.
Wipe and clean the main unit and the body
with a soft and dry cloth. Before cleaning,
unplug the power supply and power the
cleaner off.
Cut off any hair entangled on the
rollers and remove any debris using the
provided maintenance brush.
E2-3—
Use the maintenance brush carefully to avoid injury.
Insert the rear roller from the side, and
then rotate the rear roller cover from
the unlock position to the lock position
until it clicks in place.
To install the front rollers, marked red
and blue, on the correct sides of the
head. Pinch them with both hands and
align them with the front roller shaft.
Push inward to install properly.
E2-4—
E2-6—
E2-5—
Note:
Note: Do not rinse the cleaning head
directly with water.
1. Remove the dirty tank and front and rear
rollers. Switch off the vacuum cleaner and
stabilize the body.
2. Clean the roller slots and dirty water pipe
with the maintenance brush provided.
3. Wipe the charging contacts with a dry cloth.
4. Reinstall the rollers and dirty tank in place.
E3
Cleaning the Cleaning Head
and Dirty Water Pipe
E3-1— Charging Contacts
Note: Do not rinse the cleaning head directly with water.
expose the crevice tool head. The cleaning
head is switched to a crevice tool.
charging dock, and switch it off. Stabilize
the body.
Loading ...
Loading ...
Loading ...