Loading ...
Loading ...
Loading ...
9
Installing the gasket
Installation
The gasket supplied with the cooktop prevents the intrusion of liquids into the cabinet below.
Installation has to be done carefully, and in conformity with the following drawing.
Place the gasket (2) two mm from the
external edge of the glass after removing
the protection tape (3)
• IMPORTANT: A copy of the serial number must be in the instruction manual. When ordering parts for or making inquiries about your
cooktop, always be sure to include the model and serial numbers and a lot number or letter from the serial plate on your cooktop.
• Ensure that there is a distance of 2” between the cooktop and the wall or sides.
• Ideally the cooktop should be installed with plenty of space on either side. There may be a wall at the rear and tall units or a wall at one
side. On the other side, however, no unit or divider must stand higher than the cooktop.
• The piece of furniture or the support in which the cooktop is to be tted, as well as the edges of furniture, the laminate coatings and the
glue used to x them, must be able to resist temperatures of up to 212 °F.
• The mural rods of edge must be heat-resisting.
• Do not install the cooktop to the top of a not ventilated oven or a dishwasher.
• Do allow proper ventilation and a good air circulation of the electronic device,
there must be a minimum air space of 1” (2.5 cm) below the unit.
The nameplate is located under the cooktop, as shown on the picture.
Record the model and serial in manual before installing unit. When
ordering parts for or making inquiries about your cooktop, always be sure
to include the model and serial numbers and a lot number or letter from
the serial plate on your cooktop
• If a drawer is placed under the cooktop, avoid placing ammable objects in the drawer (for example: sprays) or not heat-resistant
objects.
• Materials which are often used to make worktops expand on contact with water. To protect the cut out edge, apply a coat of varnish or
special sealant. Particular care must be given to applying the adhesive joint supplied with the cooktop to prevent any leakage into the
supporting furniture. This gasket guaranties a correct seal when used in conjunction with smooth work top surfaces.
• To eliminate the risk of burns or re by reaching over heated surface units, cabinet storage space located above the surface units should
be avoided. If cabinet storage is to be provided, the risk can be reduced by installing a range hood that projects horizontally a minimum
of 5 inches beyond the bottom of the cabinets.
• The safety gap between the cooktop and the hood placed above must respect the indications of the hood manufacturer. In case of
absence of instructions respect a distance minimum of 24”.
• The power cord should have no mechanical constraint, such as an underneath drawer.
WARNING
Burn hazard
The use of cabinets for storage above the appliance may
result in potential burn hazard. Combustible items may
ignite, metallic items may become hot and cause burns.
If a cabinet storage is to provided the risk can be reduced by installing
a range hood that projects horizontally a minimum of 5" (12.7 cm)
beyond the bottom of the cabinets.
Loading ...
Loading ...
Loading ...