Loading ...
Loading ...
Loading ...
7.7.1 Remove the drawer
Drawer without pull-out system
Fig. 24
u
Remove the drawer as shown in the diagram.
Drawer on telescopic rails
Fig. 25
Make sure that the following requirements are fulfilled:
q
Drawer is completely pulled out (see Fig. 75) .
Full extension:*
Fig. 26
*
u
Lift the left clamp and simultaneously pull the drawer on
the left to the front
Fig. 26 (1)
.*
u
Lift the right clamp and simultaneously pull the drawer
on the right to the front
Fig. 26 (2)
.*
u
Remove the drawer to the front
Fig. 26 (3)
.*
u
Slide the rails in.*
Partial pull-out fridge compartment:*
Fig. 27
*
u
Pull out the drawer halfway
Fig. 27 (1)
.*
u
Lift at the front
Fig. 27 (2)
.*
u
Slide in left rail
Fig. 27 (3)
.*
u
Slide in right rail
Fig. 27 (4)
.*
u
Remove the drawer to the front
Fig. 27 (5)
.*
Fig. 28
*
If the rails are not yet fully pushed in after removing the
drawer:*
u
Push the rails in completely.*
Partial pull-out freezing compartment
Note
If the magnet on the top drawer in the freezing compart-
ment is damaged or removed, the door sensor will
malfunction.
u
Do not damage or remove the magnet.
Fig. 29
If the drawer is in the top of the freezing compartment:
u
Lift up the drawer at the front
Fig. 29 (1)
.
u
Remove to the front
Fig. 29 (2)
.
u
Slide the rails in.
Fig. 30
If the drawer is in the middle of the freezing compart-
ment:
u
Pull out the drawer halfway.
u
Lift up at the back from below
Fig. 30 (1)
.
u
Remove to the front
Fig. 30 (2)
.
u
Slide the rails in.
7.7.2 Inserting the drawer
Drawer without pull-out system
Fig. 31
Equipment
22 * Depending on model and options
Loading ...
Loading ...
Loading ...