Loading ...
Loading ...
Loading ...
BioFresh B-Value
In the delivery condition of the appliance, the value is set
to B5. The status indicator on the display shows the
appropriate target temperature in the BioFresh.
You can change this value slightly if a higher or lower
ambient temperature makes it necessary. When setting
the value, note:
Value Description
B1 Lowest temperature
B1-B4 The temperature can drop to below 32 °F (0 °C),
so food can freeze easily.
B5 Default temperature
B9 Highest temperature
BioFresh B-Value
Choosing the setting
u
Make your settings in the Customer menu
(see 6.2 Operating logic) .
D-Value
The
D-Value
is preset for your appliance and may not be
changed.
Reminder
Reminders are displayed acoustically by a beep and visu-
ally by a symbol in the display. The signal gets louder until
the alert stops.
Replace water filter
This message appears when the water filter needs
replacing.
u
Replace the water filter every 6 months.
u
Confirm the message with OK.
w
The service interval resets.
w
The water filter guarantees the best water quality.
Replace the FreshAir active carbon filter
This message appears when the air filter needs replacing.
u
Replace the air filter every six months.
u
Confirm the message with OK.
w
The service interval resets.
w
The air filter guarantees the air quality in the fridge.
Activate setting
u
Activating/deactivating (see 6.2 Operating logic) .
Reset
This function resets all settings to the factory settings. All
settings that you have made thus far will be reset to their
original values.
Activate the setting
u
Activating (see 6.2 Operating logic) .
Turn off appliance
This setting turns off the whole appliance.
Switch off whole appliance
Fig. 11
u
Turning off the IceMaker .
u
Activating/deactivating (see 6.2 Operating logic) .
w
Off: Display turns black.
6.5 Error messages
Error messages appear in the display. There are two cate-
gories of error message:
Category Meaning
Message Reminder of general procedures. You can
carry out these procedures to eliminate the
message.
Warning Appears when there are malfunctions. A
signal sounds in addition to the display. The
signal becomes louder until you acknowledge
by tapping the display. You can eliminate
simple defects yourself. For more serious
defects, you must contact customer service.
6.5.1 Warnings
Close the door
This message appears if the door is open too long.
You can set the time before this message appears .
u
Stop alarm: Confirm the message.
-or-
u
Close the door.
Use
18 * Depending on model and options
Loading ...
Loading ...
Loading ...