Loading ...
Loading ...
Loading ...
4
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed
Parts supplied
Remove parts from package. Check that all parts are included.
Parts needed
For 7" (17.8 cm) round vented installations
For 3
1
/
4
" x 10" (8.3 x 25.4 cm) rectangular vented
installations
Optional accessories
*For information on ordering, see the “Assistance or Service”
section.
Location Requirements
IMPORTANT: Observe all governing codes and ordinances.
■ It is the installer’s responsibility to comply with installation
clearances specied on the model/serial rating plate. The
model/serial rating plate is located inside the range hood on
the left wall.
■ Range hood location should be away from strong draft areas,
such as windows, doors and strong heating vents.
■ Cabinet opening dimensions that are shown must be used.
Given dimensions provide minimum clearance. Consult the
cooktop/range manufacturer installation instructions before
making any cutouts.
■ This range hood is recommended for use with cooktops with
a maximum total rating of 40,000 BTUs or less.
■ Grounded electrical outlet is required. See “Electrical
Requirements” section.
■ All openings in ceiling and wall where range hood will be
installed must be sealed.
■ These range hoods are factory set for vented installations.
Models that are capable of being installed as non-vented
(recirculating) require charcoal lters. See the “Assistance or
Service” section for information on ordering charcoal lters.
For Mobile Home Installations
The installation of this range hood must conform to the
Manufactured Home Construction Safety Standards, Title 24
CFR, Part 328 (formerly the Federal Standard for Mobile Home
Construction and Safety, title 24, HUD, Part 280) or when such
standard is not applicable, the standard for Manufactured Home
Installation 1982 (Manufactured Home Sites, Communities and
Setups) ANSI A225.1/NFPA 501A, or latest edition, or with local
codes.
Duct tape
3¹⁄4" x 10"
(8.3 x 25.4 cm) rectangular
metal vent system with
wall or roof cap
cord kit
Power
W10355452*
Part Number
Stainless steel
cleaner and
polish
31462A*
Part Number
Recirculating
kit (Charcoal
filter)
Part Number
W11371717
Caulking gun and weatherproof
caulking compound
Jigsaw or keyhole saw
Flat-blade
screwdriver
(13 mm)
Drill with
1/8"
(3 mm),
1/2"
(3 cm) bits
and 1¹⁄4"
#2 Phillips
Wire stripper
Metal snips
screwdriver
Pencil
#8-18 x
5/8
"
(4.2 x 16 mm)
#8-18 x 1"
(4.2 x 25 mm)
truss-head screws
flat-head screws
anchors
Mounting
Drywall
brackets
7" (17.8 cm) round vent
mounting plate
Part Number W10388168*
120 V, 9 W
maximum,
type E26
lamp
UL listed/CSA
wire connectors
approved
UL listed/CSA
strain relief
approved 1/2 (13 mm)
round damper
7" (17.8 cm)
7" (17.8 cm) round
metal vent system with
wall or roof cap
W10355451*
Part Number
required
Vent clamps as
Loading ...
Loading ...
Loading ...