Loading ...
Loading ...
Loading ...
11
3. For vented installations: Grease lters should be cleaned
using warm water, dishwashing liquid, and a non abrasive
brush.
For non-vented (recirculating) installations: The charcoal
lter is not washable. For information on ordering, see the
“Assistance or Service” section.
NOTE: To reduce the risk of re or shock when the hood
is used in recirculation mode, use only the conversion kit
models listed below:
Recirculating kit: W11371717
To Replace the Filter:
1. To reinstall the lter, place the back edge of the lter into the
channel at the rear of the hood. Push the lter into place and
turn the lter retainer to secure the lter to the range hood.
2. Replace the screw in the grease lter retainer.
Replacing the LED Light Bulb
Turn off the range hood and allow the light bulb to cool.
1. Disconnect power.
2. Remove the grease lters from the hood.
3. Remove the fused light bulb from behind the lamp spacer.
4. Screw a 120 V, 9 W maximum, LED light bulb with E26 base
into the socket.
5. Replace the grease lters.
6. Reconnect power.
If the new light does not operate, make sure the light bulb is
inserted correctly before calling service.
WIRING DIAGRAM
BK
For ADA compliance add these elements
during the installation
Remote Switch
Light Switch
Off - On
C25
SEL0157858A
L
G
Ground
Screw
For supply connection
use wires suitable for
at least 75° (167°F)
L
N
E26
LED BULB
BK
WH
BK
BR
BK
RD
BR
WH
RD
WH
WH
BK
Speed 2
Common
WH
Speed 1
RD
Motor Switch
Low - Off - High
Motor characterstics
Power absorption
Current
Frequency
Power Supply
Motor resistance (ohms)
White - Black
White - Red
73
±10% W
1.2
±10%A
60 Hz
120 VAC
13.6
±10% Ohms
17.1
±10% Ohms
BK
Loading ...
Loading ...
Loading ...