Loading ...
Loading ...
Loading ...
ሐ
ү
Operator Presence System:
B
e sure to check that the operator presence and interlock
systems are working properly before every use. If your
attachment does not function as described, repair the
problem immediately.
The Control Levers must be in the neutral position in
order for the machine to start. If the controls are not
exactly at neutral the unit will not start.
The attachment wire harness must be connected in order
to run the PTO system. If it is not properly or
securely connected, the PTO will not engage.
CAUTION
Stop engine, apply brakes, and remove
ignition key for safety. Disconnect spark
plug wires. Wear heavy, thick gloves
when holding onto blade. Avoid the
sharp edge of the blade.
CUSTOMER RESPONSIBILITIES
11
Overall Unit Care:
R
educe the risk of fire by removing grass, leaves and
other debris that may accumulate on the machine.
Allow the machine time to cool before cleaning or putting
it in storage.
Wash mower periodically. Clean above and below deck.
Keep all electrical connections clean and secure.
Remove any debris from around hydraulic system such
as the oil cooler, pumps and wheel motors to ensure the
system does not overheat.
Driving & Transport on Public Roads:
C
heck applicable road traffic regulations before driving
and transporting on public roads.
If the machine is transported, you should always use
approved fastening equipment and ensure that the
machine is well anchored to the towing vehicle.
WARNING
W
hen it is necessary to tilt the unit for
any repair or service, use safety chains
and/or jack stands to provide adequate
support. DO NOT rely on hydraulic or
mechanical jacks.
WARNING
S
TOP THE ENGINE AND DISCONNECT
THE SPARK PLUGS BEFRE MAKING
ANY ADJUSTMENTS TO THE MACHINE!
WARNING
D
o not overinflate the tires. Serious
injury can occur if the tire explodes
V-Belts:
Check V-belts for deterioration and wear before each use and
r
eplace if necessary. Replace belts if they begin to slip from
wear. Refer to Quick Reference and Service & Adjustment
sections of this manual for instructions on belt part numbers
and how to properly replace belts.
Tires:
M
aintain proper air pressure in all tires (SEE
SPECIFICATIONS section)
Keep tires free of gasoline, oil or insect control chemicals
which can harm rubber.
Avoid stumps, stones, deep ruts, sharp objects and other
hazards that may cause tire damage.
If operating in an area with thorns, it is recommended to fill
the tires with sealant.
POSITION “A”POSITION “A” POSITION “B”
The right side control lever acts as the
o
perator presence and depending on the
attachment will need to be in either position
“A” or position “B” to activate the attachment.
Loading ...
Loading ...
Loading ...