Loading ...
Loading ...
Loading ...
輐
ȗ
Tools Required:
• Tire pressure gauge
•
Nail bar or claw hammer
• Wire snips
• Protective eyewear
To remove the tractor from the crate:
Position crate on a flat, level surface
D
ispose of top and side panels of the crate.
Remove packing material.
Cut any banding or strapping that may be holding the tractor to the crate.
Disconnect the spark plug wire and place where it cannot make a connection.
Remove and dispose of all wheel chalks that are holding the machine in place.
Open the transmission bypasses by turning bypass ports with provided wrench one full turn.. SEE INSTRUCTION ON PAGE 13
OF OWNER’S MANUAL.
Carefully roll the tractor off the crate to a safe and level area.
Check engine oil. All engines are filled with oil and tested at the factory. Verify oil level
and add if necessary before starting engine. SEE ENGINE OWNER’S MANUAL FOR OIL
GRADE AND PROCEDURES.
Check the battery; It may need to be charged with a 12 volt charger for a minimum of
one hour, but no more than 2 hours at a rate of 6 to 10 amps.
Close the transmission bypasses by tightening the ports back to original position. Be sure that both ports are TIGHT. SEE
INSTRUCTION ON PAGE 13 OF OWNER’S MANUAL.
Reconnect spark plug wire.
Check tire pressure on both drive wheels. REFER TO UNIT SPECIFICATIONS TABLE ON PAGE
12 OF OWNER’S MANUAL.
Read all operating instructions, safety instructions and customer responsibilities
before operating this machinery.
10
Uncrating Instructions
Loading ...
Loading ...
Loading ...