Loading ...
Loading ...
Loading ...
- 23 -
Review the table for solutions to minor performance problems. Any
service needed, other than maintenance described in this Use & Care
Guide, should be performed by a qualied service dealer.
TROUBLESHOOTING
WARNING
Ensure the hard oor wet/dry vacuum cleaner is turned off before
performing maintenance to it. Failure to do so could result in
electrical shock or personal injury.
PROBLEM
POSSIBLE CAUSE SOLUTION
The hard oor
cleaner does
not turn on.
Battery may be depleted.
Charge the hard oor cleaner as
instructed on page 12-14.
Auto protection for
overheating.
Cool the hard oor cleaner down and
restart it.
Battery
indicator or
roller air drying
indicator does
not ash when
charging.
Charging plug is not
plugged into outlet rmly.
Be sure the charging plug is plugged
in properly to the outlet, and the
charging adapter is inserted into the
charging port of the storage base.
Charging adapter is not
fully plugged into the
charging port.
Be sure the charging adapter is fully
inserted into the charging port of the
storage base.
The electrical outlet is
switched off.
Ensure that the outlet is supplying
power to the charger.
Brush roller
does not turn.
Brush roller is jammed.
Remove obstruction. Follow cleaning
the brush roller instructions on page
21-22.
Brush roller is not installed
properly.
Remove the brush roller and reinstall
as instructed on page 21-22.
Brush roller
tangled
indicator is
blinking.
The brush roller is blocked.
Remove blockages. Follow cleaning
the brush roller instructions on page
21-22.
DWT full of
water indicator
is blinking.
The dirty water in DWT has
reached the MAX line.
Empty the dirty water and then
reinstall the DWT.
The ll tubes are dirty.
Clean up the
visible dirt on the ll
tubes.
CWT lack
of water
indicator is
blinking.
CWT is empty.
Rell the CWT.
Loading ...
Loading ...
Loading ...