Loading ...
Loading ...
Loading ...
USA-CAN - 10
5.BEFORE USING THE
APPLIANCE
5.1 Preparing Your Dishwasher For
First Use
• Make sure the electricity and supply water
specications match the values indicated in
the installation instructions for the machine.
• Open the door of the dishwasher.
• Remove all packaging material inside the
machine.
• Set the water softener level. (See
chapter of setting the water softener)
( model depending).
• Set the rinse aid dosage (See chapter of
lling the rinse-aid and setting).
• Fill the salt container (see chapter of
lling the dishwasher salt dispenser)
(model depending).
• Fill the rinse aid compartment. (See
chapter of lling the rinse aid and setting).
• Place the dishes in accordance with the
instructions in the user manual.
• Put adequate amount of detergent into the
detergent dispenser. (See chapter of lling
the detergent).
• Make sure that the upper and lower
impellers rotate freely.
• Select program according to amount of dirt
(See chapter of Program table).
• Close the door of the dishwasher. (Push
the baskets in. Then lift the door upwards
and push until it clicks into position).
CAUTION: To prevent injuries, ensure
that your hand is not jammed or crushed
between the door and appliance
WARNING: While the appliance is run-
ning if you open the door all functions are
automatically interrupted
CAUTION: There may be a escape of
hot steam when you open the door of your
machine. Be careful of getting injured.
5.2. Setting the Water Softener
( Model Depending )
Dishwasher needs soft water for good
cleaning results. Hard water results in a
build-up of calcium deposits on dishware
and in the dishwasher. Your dishwasher has
a special water softening system to remove
the hardness of the tap water. Setting this
system correctly will increase the washing
eectiveness.
Water supplies with a hardness level higher
than 9 °f (French Water Hardness) needs to
be softened.
If the hardness level of the water that you
use is above 9 °f (French standard for water
hardness) or if you are using well water,
than it is recommended to use lter and
water purication devices.
The dishwasher is programmed at the
factory setting level 1 (inactive) of water
hardness If this setting corresponds to the
hardness of your water, you do not need to
do anything more.
The dishwasher must be programmed for
the water hardness in your area.
To nd out the hardness level of water in
your area, contact your local Water Board
or Determine water hardness level by the
help of test strip provided.
WARNING: If you move to a dierent
location, the level of water hardness will
possibly be dierent. It is essential to setting
again the water hardness in order to obtain
optimum washing eciency.
Loading ...
Loading ...
Loading ...