Loading ...
Loading ...
Loading ...
7.2 Set RS-232
Set RS-232 parameters if you need to debug the device via RS-232 serial port.
Before You Start
The debugging device has been connected via the RS-232 serial port.
Steps
1.
Go to Conguraon → System → System Sengs → Serial Port → RS-232 .
Figure 7-2 Set RS-232
2.
Set Baud Rate, Data Bit, Stop Bit, etc.
Note
The parameters should be same with those of the connected device.
3.
Select Work Mode.
Note
●
The supported work modes vary with dierent models. The actual device prevails.
●
You need to reboot the device aer eding the work mode to take eect.
Console
Select it when you need to debug the device via RS-232 serial port.
Transparent Channel
Select it, and the network command can be transmied to RS-232 control command via the
RS-232 serial port.
Narrow Bandwidth Transmission
Reserved.
4.
Click Save.
Network Trac Camera Operaon Manual
44
Loading ...
Loading ...
Loading ...