Hikvision IDS-TCV907-BER Operation User Manual

Loading ...

Chapter 7 Serial Port Conguraon

7.1 Set RS-485

Set RS-485 parameters if the device needs to be connected to other peripheral devices controlled

by RS-485 serial port.

Before You Start

The corresponding device has been connected via the RS-485 serial port.

Steps

Note

The number of available RS-485 serial port varies with dierent models.

Go to Conguraon → System → System Sengs → Serial Port → RS-485 .

Figure 7-1 Set RS-485

Set Baud Rate, Data Bit, Stop Bit, etc.

Note

The parameters should be same with those of the connected device.

Set Work Mode.

Note

●

The supported work modes vary with dierent models. The actual device prevails.

●

You need to reboot the device aer eding the work mode to take eect.

Applicaon Trigger

Select it when a signal trigger device (such as a radar) is connected to the RS-485 serial port

of the device.

Transparent Channel

Select it when the other peripheral device is connected to the RS-485 serial port of the device

for communicaon transmission.

GPS

Select it when a GPS device is connected to the RS-485 serial port of the device to receive

posioning informaon.

Click Save.

Network Trac Camera Operaon Manual

Loading ...

Hikvision IDS-TCV907-BER 9 MP ANPR All-Rounder Traffic Camera