Loading ...
Loading ...
Loading ...
Version 23.00, November 2020
Rohde & Schwarz R&S
®
RTH1002, R&S
®
RTH1004 Handheld Oscilloscope 19
R&S
®
RTH-K3
CAN triggering and decoding
Protocol configuration
signal type
CAN_H, CAN_L
bit rate
standard bit rate (10/20/33.3/50/83.3/
100/125/250/500/1000 kbps) or user-
defined bit rate in range from 10 kbps to
1 Mbps
sampling point
10 % to 95 % within bit period
device list
associate frame identifier with symbolic
ID, load DBC file content
auto threshold setup
assisted threshold configuration for CAN
triggering and decoding (software)
Trigger
source
any input channel or logical channel
trigger event setup
start of frame, end of frame, frame type,
identifier, identifier + data, error condition
(any combination of CRC error, bit stuffing
error, form error and ACK error)
identifier setup
frame type (data, remote or both),
identifier type (11 bit or 29 bit); condition
=, ≠; identifier selectable from label list
data setup
data pattern up to 8 byte (hex or binary);
condition =, ≠
Decode
source
any input channel, logical channel
display type
decoded bus, tabulated list
color coding
start of frame, identifier, DLC, data
payload, CRC, end of frame, error frame,
overload frame, CRC error
data format
hex, decimal, octal, binary, ASCII,
symbolic
LIN triggering and decoding
Protocol configuration
version
1.3, 2.x or SAE J602; mixed traffic is
supported
bit rate
standard bit rate (1.2/2.4/4.8/9.6/10.417/
19.2 kbps) or user-defined bit rate in
range from 1 kbps to 20 kbps
signal polarity
idle low, idle high
device list
associate frame address with symbolic ID
(software)
auto threshold setup
assisted threshold configuration for LIN
triggering and decoding (software)
Trigger
source
any input channel or logical channel
trigger event setup
start of frame (sync break), identifier,
identifier + data, wakeup frame, error
condition (any combination of checksum
error, parity error and sync field error)
identifier setup
range from 0d to 63d; condition =, ≠;
identifier selectable from label list
data setup
data pattern up to 8 byte (hex or binary);
condition =, ≠
Decode
source
any input channel, logical channel
display type
decoded bus, tabulated list
color coding
frame, frame identifier, parity, data
payload, checksum, error condition
data format
hex, decimal, octal, binary, ASCII
Loading ...
Loading ...
Loading ...