Loading ...
Loading ...
Loading ...
P a g e | 27
If a gas tap becomes stiff to operate, then you should proceed as follows:
Remove the control knobs, pan supports, burners, hob fixing screws and
clamps.
Remove the hob from the worktop and remove any underside protective
covers.
Disconnect the fixings holding the tap to the fascia panel and separate
the assembly. Then clean the cone and seating with a cloth
dampened with solvent.
Lightly smear the cone with high temperature grease, reassemble into
position and rotate a few times.
Remove the cone again and remove any excess grease ensuring that
the gas
ducts are not obstructed with grease.
Carefully reassemble the components and perform a gas soundness test.
If it becomes necessary to replace a gas tap, then you should proceed as follows:
Remove the control knobs, pan supports, burners, hob fixing screws and
clamps.
Remove the hob from the worktop and remove any underside protective
covers.
Disconnect the fixings holding the tap to the fascia panel and
separate the
assembly.
Disconnect the gas pipe from the gas tap, and then disassemble them from
the gas
rail by removing the fixing screws.
When fitting a new tap, ensure that a new gasket is used.
Reconnect the gas tap, perform a gas soundness test and then reassemble
the hob.
6.12ELECTRICAL CONNECTION
Power hard wiring connection of the cooktop must be installed by a licensed
electrician.
Before connecting the appliance, make sure that the supply voltage
marked on the
rating plate corresponds with your mains supply voltage.
Cable type: H05 RRF 3 core x 0.75 mm³ (Type RR-F <HAR> marked).
The mains supply cable and plug are supplied with this product.
web:brohn.com.au
Loading ...
Loading ...
Loading ...