Loading ...
Loading ...
Loading ...
Heritage & Titan Gas Ranges
Use & Care Manual
13592 Desmond St., Pacoima, CA 91331 818.897.0808 tel 888.753.9898 toll free www.americanrange.com
6
The location selected for the range must meet the following criteria. If any of these criteria are not met, select another location.
Important - The maximum depth of the overhead cabinets installed on either side of the hood is 13".
SITE PREPARATION
0 The range is a free standing appliance. If the range is to be installed adjacent to cabinets, the clearances where indicated are
required.
This range may not be recessed into the cabinets. The rear of the oven door must be beyond the edge of the front face of the
adjacent cabinet.
The gas and electrical supplies should be located below the unit or in the adjacent right cabinet.
Any openings in the wall behind the range and in the oor under the range must be sealed.
Always keep the appliance free and clear of combustible materials, gasoline, or other ammable vapors and liquids.
Do not obstruct the ow of combustion exhaust and ventilation air to the unit.
CABINET PREPARATION
Check cabinet materials to be sure they can be used in proximity of the Range.
The maximum depth of overhead cabinets installed on either side of the hood is 13".
When there is less than 12" clearance between combustible material and the back edge of the Range above the cooking
surface, a backguard must be installed.
When clearance to combustible material is over 12" no backguard is necessary.
Backguards must be ordered separately.
ELECTRICAL CONNECTION
0
The Range must be electrically grounded in compliance with local codes or, in the absence of local codes, with the
National Electrical Code, ANSI/NFPA70.
This range requires a 120 volt supply to operate the ignition system. The supply cord provided on the range is equipped with
a three-prong (grounding) plug for protection against electrical shock.
The electrical service in the building must be equipped with a properly grounded three-prong receptacle.
Do not cut or remove grounding prong from this plug.
POWER REQUIREMENTS FOR THIS RANGE
120 VAC, 60 Hz, single phase, 15 AMP Max
GAS CONNECTION
Be certain the appliance gas type matches the gas service being provided. Refer to the appliance rating label for the gas supply
requirements.
A manual gas shut-off valve must be remotely installed and easily accessible in the adjacent cabinet. The regulator inlet is for a 1/2"
gas line.
0 Use at least a 1/2" inside diameter commercial ex hose to connect range to the gas supply (service line).
A manual gas shut-off valve must be installed, in easy access in front of the gas supply (service line) and ahead of the range for
safety and ease of maintenance.
All valves must be in the OFF position before connecting to the gas supply line.
INSTALLATION INSTRUCTIONS
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
Loading ...
Loading ...
Loading ...