Loading ...
Loading ...
Loading ...
Rails en
35
4.
Remove the pull-out rail.
5.
Clean the pull-out rail.
→"Cleaning products", Page28
Note:
Further information:
23.4 Attaching the pull-out rail
Note:The pull-out rails only fit on the right or left. Make
sure when you fit them that you can pull them out to-
wards the front.
1.
Guide the pull-out rail with the rear retainer
from
below behind the two guide rods for the required
shelf position and keep it horizontal.
2.
Guide the rail lengthways to the rear to the guide
rods, and slide both retainers onto each lower rod.
In doing so, use the rear retainer to grip the ver-
tical rod.
3.
Press and hold PUSH and swing the pull-out rail
inwards until the retainer is attached in the
lower rod.
a
4.
Release the PUSH tab.
a The retainer clicks into place.
5.
Pull the pull-out rail out as far as it will go and slide
it back in.
Note:
Further information:
Loading ...
Loading ...
Loading ...