Loading ...
Loading ...
Loading ...
TRUE RESIDENTIAL
®
TEC_TM_155 | REV. D | EN09/23/2022Page 52 of 66
P#829867
MAINTENANCE, CARE & CLEANING
SANITIZING
1. Remove the ice guide, water supply, spray bar and
pump clean-out cap. See "Interior Components"
(page 53).
2. Mix 1.5 fluid ounces (3 tbsp) of 5.25%
hypochlorite solution (chlorine bleach) with 3
gallons of warm water.
3. Use 1/2 of the solution to sanitize the removed
parts. Soak the parts in the solution. DO NOT RINSE
THE PARTS AFTER SANITIZING.
4. With the remaining solution, sanitize the interior
surfaces of the machine and the bin. DO NOT
RINSE THE SANITIZED AREAS.
5. Reinstall the components.
6. Press and hold CLEAN for 3 seconds. The display
will show dES.
7. Press LIGHT and / or CLEAN until the display shows
either SAn (descale only) or bth (both descale and
sanitize).
8. With the display showing the desired cycle, press
the TRUE logo. The display will show Str.
9. Press LIGHT and / or CLEAN until the display
shows either Str (startup) or Stb (standby).
This determines the ice machine's action upon
completion of the selected cleaning cycle.
10. With the display showing the desired action,
press the TRUE logo. The selected cleaning cycle
will begin.
Run Sanitize
cycle only
Run both descale
and sanitize cycles
Machine will begin
ice making sequence
Machine will
enter standby
11. The display will alternate between PrE and CLn
(preclean) for approximately 3 minutes.
12. When the display shows Add, pour 2 teaspoons of
5.25% hypochlorite solution (chlorine bleach) into
the spray compartment behind the water shutters.
13. After adding the sanitizer solution, press the TRUE
logo. The automatic cycle will continue.
14. Wait for the sanitizing cycle to finish. Immediately
rinse off and dry any exterior areas where
sanitizing solution may have spilled.
Add cleaning
chemicals
Preclean stage
While running the
automatic clean cycle
Loading ...
Loading ...
Loading ...