Loading ...
Loading ...
Loading ...
AXIS A4011-E Reader
Install the Hardware
1. Remove the frontplate screw and remove the frontplate from the reader backplate.
2. Prepare the wall for installation of the reader. Hold the backplate against the surface
and mark the holes with a pencil. Make sure to use drill bits, screws and plugs that
are appropriate for the material.
Power & Data connector (pin 1–4)
1
DC input
2
0 V DC (-)
3
RS485 (A)
4
RS485 (B)
Other hardware
5
Tab (2x)
6
Tampering sensor
7
Silicone gasket (2x)
8
Frontplate screw (T20)
3. Strip and connect the wires. For specications, see Power & Data Connector on page 8 .
4. Make sure that the silicone gaskets are positioned correctly.
5. Hook the frontplate onto the tabs on the backplate and push the front panel into place.
6. Tighten the screw.
Further Information
Visit Axis learning center www.axis.com/academy for useful trainings, webinars, tutorials and
guides.
10
Loading ...
Loading ...