Loading ...
Loading ...
Loading ...
Page 26
4. Once the correct level is met, make sure the dipstick is tight within the engine block.
NOTICE
The low oil sensor (if equipped) will automatically stop the engine when the oil level falls
below the safe limit. To avoid an unexpected shutdown, check the oil level regularly, ll to
the upper limit, and always operate engine on a level surface.
LOW OIL SENSOR
Engine Fuel
Gasoline
LOOK BEFORE YOU PUMP!
It is imperative to use fresh (less than 30 day old) gasoline with a minimum octane
rating of 87 and a maximum ethyl alcohol level of 10%.
Add fuel to the pressure washer by following these steps:
1. Check fuel with the engine o and the pressure washer trailer on a level surface.
2. Remove the fuel cap to verify the fuel level. For the fuel cap location, see the
COMPONENTS LOCATION section of this manual.
3. Use clean, fresh, regular unleaded gasoline with a minimum octane rating of 87.
Do not mix fuel and oil! Only use fuel with a maximum ethyl alcohol level of 10%. E15,
E20 and E85 are not approved fuels. ENGINE DAMAGE MAY OCCUR BY USING
THESE FUELS.
4. Do not ll the fuel tank
above the maximum fuel
level to allow room for use
expansion.
5. Replace the fuel cap.
Never run the engine or
pressure washer without
the fuel cap(s) installed.
Maximum fuel level
Engine mounted tank
Frame mounted tank
Maximum fuel level
NOTE: Using a fuel
stabilizer (sold separately)
when storing gasoline can
help to prevent problems
related to ethanol alcohol
blended gasoline. Always
follow the instructions on
the bottle and mix throughly.
Loading ...
Loading ...
Loading ...