Loading ...
Loading ...
Loading ...
6
Ring Alarm Range Extender – Exclusion
Removing Ring Alarm Keypad from a Z-Wave Network
Exclusion Instructions:
1. Initiate remove “Ring Alarm Range Extender” flow in the Ring Alarm mobile application – Select the
settings icon from device details page and choose Remove Device to remove the device. This will
place the controller into Remove or “Z-Wave Exclusion” mode.
2. Locate the pinhole reset button on the back of the device.
3. With the controller in Remove (Z-Wave Exclusion) mode, use a paper clip or similar object and tap
the pinhole button. The device’s red LED turns on solid to indicate the device was removed from
the network.
Ring Alarm Range Extender – Factory Reset
Factory Default Instructions
1. To restore Ring Alarm Range Extender to factory default settings, locate the pinhole reset button on
the device. This is found on the back of the device after unplugging the device from the outlet.t.
2. Using a paperclip or similar object, insert it into the pinhole, press and hold the button down for
10 seconds.
3. The device will rapidly blink green continuously for 10 seconds. After about 10 seconds, when the
green blinking stops, release the button. The red LED will turn on solid to indicate the device was
removed from the network.
Note
Use this procedure only in the event that the network primary controller is missing or otherwise
inoperable.
Wake-Up Notification
Not applicable. Ring Alarm Range Extender is an Always On Slave (AOS) and does not support Wake
Up Command Class.
Loading ...
Loading ...
Loading ...