1. Home
  2. Perlick
  3. Perlick H80CIMSR User Manual
  4. Page 27

Perlick H80CIMSR 15 Inch Built-In Undercounter Nugget Ice Maker with 3.40 Cu. Ft. Capacity, 80

Manual - Page 27

For H80CIMSR.

PDF File Manual, 34 pages, Read Online | Download pdf file

H80CIMSR photo
Loading ...
Loading ...
Loading ...
PERLICK RESIDENTIAL UNDERCOUNTER CUBELET ICE MAKER PRODUCT MANUAL
perlick customer service (800)558-5592 | 27
MAINTENANCE
MAINTENANCE SCHEDULE
Frequency Area Task
Weekly Scoop Clean the scoop using a neutral cleaner. Rinse thoroughly aer cleaning.
Monthly
Drain the Appliance Move the control switch to the "DRAIN" posion. Allow the water system to drain for
1 minute. Clear ice away from the thermostac bin control bulb. Move the control
switch to the "ICE" posion. Aer the gear motor starts, move the control switch to
the "DRAIN" posion. Allow the water system to drain for 1 minute. Move the control
switch to the "ICE" posion to start the automac icemaking process.
Appliance Exterior Wipe down with clean, so cloth. Use a damp cloth containing a neutral cleaner to
wipe o oil or dirt build up. Clean any chlorine staining (rust colored spots) using a non-
abrasive cleanser.
Every 3 Months Storage Bin Drain Maintain as outlined in Storage Bin Drain (pg 30)
Every 6 Months Icemaker and
Storage Bin
Clean and sanize per the cleaning and sanizing instrucons provided in this manual.
Evaporator
Condensate Drain
Pan and Gear Motor
Drain Pan
Wipe down with clean cloth and warm water.
Gear Motor
Drain Pan
Evaporator
Condensate
Drain Pan
Oponal Drain Pump
(63802A)
Test as outlined in Oponal Drain Pump 63802A instrucons
External Water Filters Check for proper pressure and change if necessary.
Yearly Water Supply Inlet Close the water supply line shut-o valve and drain the water system. Clean the water
supply inlet screen.
Condenser Inspect. Clean if necessary.
Water Hoses Inspect the water hoses and clean/replace if necessary.
Upper Bearing
(extruding head)
Check for wear using .02" round stock or pin gauge. Replace both upper bearing and
lower bearing if wear exceeds factory recommendaons.
Aer 3 Years,
then Yearly
Upper Bearing
(extruding head);
Lower Bearing
and O-Ring (lower
housing); Mechanical
Seal; Evaporator
Cylinder; Auger
Inspect. Replace both upper bearing and lower bearing if wear exceeds factory
recommendaons. Replace the mechanical seal if the seal's contact surfaces are worn,
cracked, or scratched.
Loading ...
Loading ...
Loading ...