Loading ...
Loading ...
Loading ...
11
www.insigniaproducts.com
Full Motion Mount for TVs 47" - 80"
STEP 5 - Option 2: Installing on a solid concrete or concrete
block wall
CAUTION:
To prevent property damage or personal injury, never drill into the mortar between
blocks. Mount the wall plate directly onto the concrete surface.
1
Align the center of the wall plate template at the height (a + b) you determined in the previous step,
make sure that it is level, then tape it to the wall.
2
Drill six pilot holes through the template to a depth of 2.28 in. (58 mm) using a 3/8 in. (10 mm) diameter
masonry drill bit, then remove the template.
3
Insert the concrete wall anchors (B2) into the pilot holes and use a hammer to make sure the anchors are
flush with the concrete surface.
4
Make sure that the wall-mount arm on the wall-mount is perpendicular to the wall plate, align the wall
plate with the anchors, insert the lag bolts (B1) through the lag bolt washers (B3), then through the
holes in the wall plate. Make sure that the wall plate is level, then tighten the lag bolts with the box
wrench only until they are firm against the wall plate.
CAUTION:
DO NOT over-tighten the lag bolts (B3).
.
You’l l need
2.28 in. (75 mm)
* Minimum solid concrete thickness:
8 in. (203mm)
* Minimum concrete block size:
8 x 8 x 16 in. (203 x 203 x 406 mm).
* Minimum horizontal spacing between
fasteners cannot be less than
16 in. (406 mm).
Align the center of the
template with the
height mark (a+b) you
made in step 4.
3/8 in. (10mm)
Concrete wall
Magnetic
removable bubble
level
B2
B3
B1
Box
wrench
B2 (6)
Drill
3/8 in.
masonry
drill bit
B3 (6)
Wall plate
template
B1 (6)
Hammer
Wall mount
Box
wrench
Magnetic
removable
bubble level
Tape
NS-HTVMM1703-C_16-0801_MAN_V6_EN.fm Page 11 Tuesday, October 11, 2016 10:26 AM
Loading ...
Loading ...
Loading ...