Loading ...
Loading ...
Loading ...
NS-HTVMM1703-C
10
www.insigniaproducts.com
STEP 5 - Option 1: Installing on a wood stud* wall
Note: Any drywall covering the wall must not exceed 5/8 in. (16 mm).
1
Locate the stud. Verify the center of the stud with an edge-to-edge stud finder.
2
Align the center of the wall plate template at the height (a + b) you determined in the previous step,
make sure that the template is level, then tape it to the wall.
3
Drill four pilot holes through the template to a depth of 2 in. (50 mm) using a 3/16 in. (5 mm) diameter
drill bit, then remove the template.
4
Make sure that the wall-mount arm on the wall-mount is perpendicular to the wall plate, align the wall
plate with the pilot holes, insert the lag bolts (B1) through the lag bolt washers (B3), then through the
holes in the wall plate. Make sure that the wall plate is level, then tighten the lag bolts with the box
wrench only until they are firm against the wall plate.
CAUTION:
Use only the four center holes to mount the wall plate. Do not use the slotted side holes.
• DO NOT over-tighten the lag bolts (B3).
You’ll need
* Minimum wood stud size: common 2 x 4 in. (51 x 102 mm) nominal 11/2 x 31/2 in. (38 x 89 mm).
* Minimum horizontal spacing between fasteners cannot be less than 16 in. (406 mm).
Align the center
of the template
with the height
mark (a+b) you
made in step 4.
2 in. (50 mm)
3/16 (5 mm)
B3
B1
Box
wrench
Magnetic
removable
bubble level
Stud
finder
Stud
Edge-to edge
stud finder
Drill
3/16 in. wood
drill bit
Wall plate
template
Tape
B1 (4)
B3 (4)
Box wrench
Magnetic
removable
bubble level
Wall mount
NS-HTVMM1703-C_16-0801_MAN_V6_EN.fm Page 10 Tuesday, October 11, 2016 10:26 AM
Loading ...
Loading ...
Loading ...