Loading ...
Loading ...
Loading ...
Introduction
11
1
1.6 Connecting the Camera
The camera comes with a data cable that allows you to connect the camera to the power
adapter, microphone, speaker, and I/O devices.
Audio In
Ethernet
Audio Out
Alarm In
Alarm Out
RS-485 (not available for GV-SD2322-IR)
Video Out (BNC)
Power (not applicable for GV-SD4825-IR)
Power adapter (only applicable for GV-SD4825-IR)
Figure 1-14
1. Connect the power adapter to the 3-pin terminal block, or connect the Ethernet cable to
the PoE port. Either of the red or black cables can be used for anode (+) and the
cathode (-).
Power Adaptor
Figure 1-15
2. Connect a standard network cable to the Ethernet cable of the camera.
3. Optionally connect the TV-out (BNC) cable to a monitor. The TV-out function can be
used during installation to adjust the camera image.
4. Optionally connect I/O devices, speaker and microphone to the camera. You can
connect up to 2 alarm inputs and 1 output device. See Wire Definition section below.
Each time the camera is powered on, it will perform a self-test to check the Pan/Tilt/Zoom
(PTZ) function. After the self-test, you can operate the camera.
Note: If you are using your own power adapter, you may need to ground the camera using
the yellow cable (GND) on the 3-pin terminal block.
Loading ...
Loading ...
Loading ...