Loading ...
Loading ...
Loading ...
Two piece-shaft
Apply grease to the end of the drive shaft after
each 30 hours of operation. There is a risk
that the drive shaft ends (splined coupling) on
models with two-piece shafts will seize if they
are not lubricated regularly.
Troubleshooting
Keypad
Power button LED flashes Possible faults Possible action
Continuous Low battery power. Charge the battery.
2 flashes Undervoltage.
1. Turn off the product.
2. Turn on the product again.
3. If the problem continues, speak to
your servicing agent.
3 flashes Bad battery. Replace the battery.
4 flashes Overcurrent.
1. Turn off the product.
2. Turn on the product again.
3. If the problem continues, speak to
your servicing agent.
5 flashes High temperature. Let the product cool down.
6 flashes Rotation block fault.
1. Turn off the product.
2. Turn on the product again.
3. If the problem continues, speak to
your servicing agent.
9 flashes Protection mode activated.
1. Turn off the product.
2. Turn on the product again.
3. Change your work method if the
protection mode turns on again.
10 flashes Battery communication er-
ror.
1. Remove the battery.
2. Clean the battery connectors with
compressed air or a soft brush.
3. Install the battery again correctly.
2113 - 004 - 03.11.2023
27
Loading ...
Loading ...
Loading ...