Loading ...
Loading ...
Loading ...
To install the harness support hook
1. Install the harness support hook between
the loop handle and the throttle handle.
Note: Do not put the support hook on the
decal.
2. Tighten the 2 screws with the hex key.
3. Adjust the ring to make the product
balanced, and easy to use.
To assemble the cutting head
CAUTION: Make sure that the
drive shaft inside the shaft engages
with the cut-out in the cutting head.
B
A
C
1. Loosen the clamp screw (B) and remove
the set screw (A).
2. Align the arrow on the shaft with the set
screw hole in the gearbox.
3. Push the shaft until the line mark (C)
touches the gearbox.
4. Align the set screw holes in the shaft and
the gearbox.
5. Replace and tighten the set screw.
6. Tighten the clamp screw.
To assemble the bar and chain
1. Unscrew the bar nut and remove the
protective cover.
2. Fit the bar over the bar bolt. Place the bar
in its rearmost position. Place the chain
over the drive sprocket and in the groove
on the bar. Begin on the top side of the
bar.
3. Make sure that the edges of the cutting
links are facing forward on the top edge of
the guide bar.
4. Fit the cover and locate the chain adjuster
pin (A) in the hole in the bar. Check that
the drive links of the chain fit correctly on
the drive sprocket (B) and that the chain
is in the groove in the bar. Tighten the bar
nut finger-tight.
A
B
5. Tension the chain by turning the chain
tensioning screw clockwise using the
combination wrench. The chain should be
tensioned until it does not sag from the
underside of the bar.
14
2113 - 004 - 03.11.2023
Loading ...
Loading ...
Loading ...