Loading ...
Loading ...
Loading ...
20
NOTE: If you are unable to resolve an issue using the troubleshooting guide above, please
contact Customer Service at [email protected]om.
E02: Burst clash protection
Incoming voltage is lower
than 50% of the required
voltage.
Check that the incoming power
supply is the correct voltage.
E05: Current overload
protection (Self Protecting
System)
The incoming voltage is
too low or too high. The
control board is damaged.
Restart the treadmill. Check the
incoming voltage to ensure it is
correct.
Check the control board,
replace if damaged.
A moving part of the
treadmill is stuck and
therefore the
motor is
unable to rotate properly.
Inspect moving parts of the
treadmill to ensure that they are
operating correctly. Check the
motor, listen for strange noise
and check for a burning smell.
Replace the motor if necessary.
E06: Motor Abnormality
The
motor wire is not
connected, or the motor is
damaged.
Check motor wires to see if the
motor is connected. If the wire
has been punctured or
damaged, you will need to
replace it. If the problem is not
rectified, you may need to
replace the motor.
E08: Cont
rol Board
Abnormality
The control board is not
connected.
Check the upper and middle
wires to see if the control board
is connected. If the wire has
been punctured or damaged,
you will need to replace it. If the
problem is not rectified, you may
need to re
place the control
board.
E10: Motor Abnormality
The motor is damaged or a
moving part of the treadmill
is stuck and therefore the
motor is unable to rotate
properly.
Inspect moving parts of the
treadmill to ensure that they are
operating correctly.
Replace the motor if necessary.
Loading ...
Loading ...
Loading ...