Loading ...
Loading ...
Loading ...
Risk of unsafe
operation. Do not
use damaged or worn accessories.
Risk of Bursting.
Too much air
pressure causes a hazardous risk of
bursting. Check the manufacturer's
maximum pressure rating for air
tools and accessories. The regulator
outlet pressure must never exceed
the maximum pressure rating.
Now to Start
1. Turn the Off/Auto switch to
"AUTO" and allow tank pressure
to build. Motor will stop when
tank pressure reaches "cut-out"
pressure.
2. Turn the regulator knob clock-
wise until desired pressure is
reached.
The compressor is ready for use.
Risk of unsafe
operation.
Compressed air from the unit may
contain water condensation and
oil mist. Do not spray unfiltered air
at an item that could be damaged
by moisture. Some air tools and
accessories may require filtered
air. Read the instructions for the air
tools and accessories.
CUSTOMER RESPONSiBiLiTiES
Before
each
use
o
Daily or See tank
after each warning label
use
iCheck Safety Valve
Drain Tank
Remove tank from service
il- For more information, contact a Trained
o
• (1)
Service Technician
_Risk of Unsafe
-- Operation. Unit
cycles automatically when power is
on. When performing maintenance,
you may be exposed to voltage
sources, compressed air or moving
parts. Personal injuries can occur.
Before performing any maintenance
or repair, disconnect power source
from the compressor and bleed off
all air pressure.
NOTE: See Operation section for the
location of controls.
TO CHECK SAFETY VALVE
_Risk of Bursting.
__ If the safety valve
does not work properly, over-
pressurization may occur, causing
air tank rupture or an explosion.
_Risk from Flying
__ Objects. Always
wear certified safety equipment:
ANSi Z87.1 eye protection (CAN/CSA
Z94.3) with side shields.
Before starting compressor, pull the
ring on the safety valve to make sure
that the safety valve operates freely.
If the valve is stuck or does not oper-
ate smoothly, contact a trained service
technician.
15- ENG
Loading ...
Loading ...
Loading ...