Loading ...
Loading ...
Loading ...
Trouble shooting en
55
Demo mode
If the ò symbol is shown on the display, demo mode is
active. The appliance does not heat up in demo mode.
Disconnect the appliance from the power supply. Wait a
few seconds before reconnecting the appliance. Then
deactivate demo mode in the basic settings within
3 minutes of switching on the appliance.
The cooking zone has been operating continuously for an
extended period.
The automatic safety shut-off function has been activated. See the section entitled
The hob is unable to connect to your home network or the
extractor hood. “ˆ‹‚‹
Acknowledge the fault code by touching any of the buttons. You can cook as usual
without a connection.
If this code is displayed again, contact the technical after-sales service.
The cooking sensor has overheated and the cooking zone has
been switched off. “‰ƒ‹ƒ
Wait until the cooking sensor has cooled down sufficiently before activating the func-
tion again.
The cooking sensor has overheated and all the cooking zones
have been switched off. “‰ƒ‹„
If you are not using the cooking sensor, remove it from the cookware and keep it
away from the other cooking zones and sources of heat. Switch the cooking zones
back on.
The battery in the cooking sensor is almost drained. “‰ƒ‹…
Replace the 3 V CR2032 battery. See the section entitled ~ "Changing the battery"
The connection to the cooking sensor has been broken.
“‰ƒ‹†
Switch the function off and then on again.
The cooking sensor is faulty. “‰ƒ‹‡
Contact the technical after-sales service.
The cooking sensor indicator will not light up and the cooking
sensor is not responding.
Replace the 3 V CR2032 battery. See the section entitled ~ "Changing the battery"
If this does not solve the problem, press and hold the symbol on the cooking sensor
for 8-10 seconds and then reconnect the cooking sensor to the hob. See the section
entitled
If the problem persists, contact the technical after-sales service.
The indicator on the sensor flashes twice. The battery in the
cooking sensor is almost drained. You may be interrupted the
next time you cook by the battery running out.
Replace the 3 V CR2032 battery. See the section entitled ~ "Changing the battery"
The indicator on the sensor flashes three times. The connec-
tion to the cooking sensor has been broken.
Press and hold the symbol on the cooking sensor for 8-10 seconds and then recon-
nect the cooking sensor to the hob. See the section entitled ~ "Connecting the
wireless temperature sensor to the control panel"
The operating voltage is incorrect/outside of the normal oper-
ating range. “Š‹‹‹/“Š‹‚‹
Contact your electricity supplier.
The hob is not connected properly —…‹‹
Disconnect the hob from the mains power supply. Make sure that it has been con-
nected as shown in the circuit diagram.
Problem Solution
Loading ...
Loading ...
Loading ...