Loading ...
Loading ...
Loading ...
31
bromic.com/heat
MAINTENANCE & SERVICING
MAINTENANCE
IMPORTANT NOTES & WARNINGS
WARNING
This heater MUST be installed by an authorised/ licenced person. Do not perform maintenance,
or carry out installation or assembly procedure while electrical power is switched on.
!
IMPORTANT
Check product label for correct voltage and wattage to ensure power source conforms to
the heater’s requirements.
Make all connections in accordance with local electrical code regulations. For outdoor
installation, all connections must be made in accordance with local electrical code
regulations for outdoor wiring.
OVERCURRENT DEVICE: The outputs are NOT protected against short circuits or extra-
currents which can damage the electronic board. Evaluate the characteristics of the
connected loads and apply the appropriate safety devices to the power line.
Check surrounding area of heater for hazards before turning on.
!
DANGER
ELECTRICAL SHOCK HAZARD! Serious injury or death may occur. Disconnect from electrical
supply before installing or servicing this heater. Read and follow installation clearance
requirements outlined in this manual. The appliance MUST be connected to a properly grounded
electrical source. Isolate mains before installing. Use only with a properly secured heater.
• For longest product life, and to maintain product appearance, mount heater under cover
and protect from rain and weather whenever possible.
• Before cleaning ensure the appliance is o and has been o for at least 2 hours after
operation. The heater must be cool to touch before cleaning can begin.
• The exterior housing of the heater should be cleaned regularly. Use a clean, soft, damp
cloth. Salt in the air can cause rusting of metal, especially at locations near the coast.
Additional cleaning of the heater with a soft damp cloth fortnightly will aid in maintaining
the product’s appearance. Do not clean heater with cleaners that are combustible or
corrosive.
• Improper cleaning of the front of the appliance can cause scratching and reduce the
appearance of the appliance. Below guidelines must be read before cleaning the front of the
appliance and must be followed to maintain the quality of the surface finish.
DO NOT DO
Do not use harsh cleaning pads or sharp tools.
Do not use harsh cleaning chemicals.
Do not spray the appliance with water for cleaning.
Use a clean, soft, damp microfibre cloth.
Use lukewarm water and a mild dish washing deter-
gent.
Do not use a dry cloth or your hand to wipe clean
the surface.
Using a dry cloth or your hand to clean the surface
will rub dirt and dust into the surface and may cause
scratching or damage.
Use a microfibre cloth in the lukewarm water solution.
Rinse out the cloth frequently to remove any dirt and
dust from the cloth to avoid scratching the surface.
Do not apply pressure and rub the surface.
Do not apply continuous, erratic scrubbing.
Gently wipe the microfibre cloth across the surface.
Apply minimum pressure to avoid scratching.
Minimise contact with the surface.
Use the same directional stroke, lift hand and repeat.
Do not bu dry with a cloth that could cause
scratching.
Allow surface to air dry.
Loading ...