Loading ...
Loading ...
Loading ...
23
bromic.com/heat
23
ELECTRICAL INSTALLATION – PENDANT HEATERS
bromic.com/heat
IMPORTANT NOTES & WARNINGS
WARNING
DANGER
IMPORTANT
This heater MUST be installed by an authorised/licenced person. Do not perform maintenance,
or carry out installation or assembly procedure while electrical power is switched on.
ELECTRICAL SHOCK HAZARD! Serious injury or death may occur. Disconnect from electrical
supply before installing or servicing this heater. Read and follow installation clearance
requirements outlined in this manual. The appliance MUST be connected to a properly grounded
electrical source. Isolate mains before installing. Use only with a properly secured heater.
Pendant Heater controls generate heat during operation. Controls MUST be mounted in a clean,
dry and well-ventilated position, with clearance on all sides, and where ambient temperature
does not exceed 30°C. Controls MUST remain cool at all times.
Controls MUST NOT be installed in a confined space, close to other heat generating appliances
or in the case of a multi-control installation, a minimum clearance of 300 mm between all sides
of adjacent controls. For further questions please contact Bromic technical support services.
Check product label for correct voltage and wattage to ensure power source conforms to the
heater’s requirements.
Use appropriate power supply cables for the heaters’ voltage and wattage. The fixed wiring
must be positioned away from & protected from the enclosure of the heater.
Make all connections in accordance with local electrical code regulations. For outdoor
installation, all connections must be made in accordance with local electrical code regulations
for outdoor wiring. Only use wiring components approved for outdoor use with minimum IP54
rating.
PLUG AND SUPPLY CORD: Use an appropriately rated plug and supply cord - check the power
requirements of the connected loads. Socket outlet used must be near the equipment.
Study the WIRING DIAGRAM at the end of this document before starting installation.
OVER CURRENT DEVICE: The outputs are NOT protected against short circuits or extra-
currents which can damage the electronic board. Evaluate the characteristics of the connected
loads and apply the appropriate safety devices to the power line.
ISOLATION SWITCH: This product does not have a switch for electrical disconnection. A means
for disconnection of the heater must be incorporated in the wall socket & fixed wiring according
to the local electrical codes.
The Pendant Heater Control must be mounted using the following guidelines:
• It must be fixed on surfaces which cannot be damaged by high temperature or UV.
• It must be fixed in a well-ventilated location where ambient temperature does not exceed
30°C.
• Connection cables must be protected against any accidental impacts, using proper
piping/conduits.
• Do not cover the product.
• Do not use or store flammable materials close to the product.
!
!
!
Loading ...
Loading ...
Loading ...