Loading ...
Loading ...
Loading ...
Proper care and cleaning are important so your range
will give you efficient and satisfactory service. Follow
these directions carefully in caring for it to help assure
safe and proper maintenance.
BE SURE EI_FCTRICAI POWER IS
DISCONNECTED BEFORE CLEANING ANY
PART OF YOUR RANGE.
Sealed Burner Assemblies
(on some models)
CAUTION: DO NOT OPERATE THE BURNER
WITHOUT ALL BURNER_ PARTS AND DRIP
PANS (IF SO EQUIPPED) IN PLACE.
Grate
/_'_\ ..............Burner cap
__,_ Drip pan
(on some models)
...............4 Burner head
_ \'!'_,_ Burner base
Turn all the controls off before removing burner
parts and drip pans (ff so equipped).
The burner grates, caps, heads and drip pans
(if so equipped) can be lifted off, making them easy
to clean.
The electrode of the _! _\ ,_
spark igniter is exposed Electrode
when the burner head ]_ x;)
is removed. When one
burner is turned to LITE, all the burners spark.
Do not attempt to disassemble or clean around
any burner while another burner is on. An electric
shock may result, "which could cause you to knock
over hot cookware,
Burner Heads
(on sealed burners only)
NOTE: Before removing the burner heads and
caps, remember their size and location. Replace
them in the same location after cleaning.
For proper ignition, make
sure the small hole in the
section that fits over the
electrode is kept open.
A sewing needle or wire
twist-tie works well to
unclog it.
The slits in the burner heads of your range
must be kept dean at all times for an even,
unhampered flame.
You should clean the surface burners routinely,
especially after bad spillovers, which could clog these
openings.
To remove burned-on food, soak the burner heads
in a solution of mild liquid detergent and hot water
for 20-30 minutes. For more stubborn stains, use a
toothbrush.
Before putting the burner head back, shake out
excess water and then dry it thoroughly by setting
it in a warm oven for 30 minutes.
Replace the burner heads
and caps. Make sure that
the heads and caps are
replaced in the correct
location. There is one
small, 2 medium and one
large cap.
NOTE: On some models
the burner heads and caps
are all the same size and can be
used in any of the 4 needed locations.
After cleaning, make sure
the slot in the burner head
is positioned over the
electrode,
22
Loading ...
Loading ...
Loading ...