Loading ...
Loading ...
Loading ...
USING YOUR ICE MAKER
Because the water in the big water reservoir is stopped to drain port by
the water valave, if you want to drain away all the water, please plug on
the unit and but don’t start the unit, then remove the drain port cap at
the back. Wait some minutes, and all of the water will flow out.
2.When you plug the unit, the power symbol< > will flash. Press the
<ON/OFF> button, the unit will start making ice cube, ice making
symbol< > will keep running. The left up corner of display area will
show the ambient temp, i.e: 80℉ means the ambient temp is 80℉.
After several mins, this area will show flash number, the ice making will
countdown, i.e: 10M means the ice making will finish 10 mins later.
3.When ice maker harvest, symbol< > flash, the water will flow
from top water reservoir to bottom water tank through solenoid valve,
the symbol < > will be on, when the water in the bottom water tank
is full,the symbol < > will be off, then the next ice making cycle
start again. When there is no water in the water reservoir, the symbol
< > will keep on. Turn off the unit and fill water again, then restart
the unit to make ice cube. Or fill water directly and wait 20mins, the
unit will restart.
1.Remove the cover of the
water reservoir and pour
potable water into water
reservoir.
And be sure to keep water
level below the max. level
with FULL mark displayed in
following picture. Then
move back the cover at once
to avoid foreign matter
enter.
Warning: Do not pour the
water into the internal water
tank located underneath the
ice basket. This tank is not
big enough and will effect
the ice making performance.
Operation panel and display area
DISPLAY AREA
Cover for the
water reservoir
OPERATION AREA
TIMER ON/OFF -+
09
EN
Loading ...
Loading ...
Loading ...