Ancona AN-1419 User Manual

Loading ...

— 12 —

STEP 7

Installing the hood mounting bracket

• The ceiling must be able to bear at least 40 kg (88 lbs.) of weight, and the thickness of the ceiling must be at least 30

mm (1.8 po).

• Drill 1 × 170 mm (6.7 po) round hole in the ceiling.

• Run house electrical wires to the electrical box on the bracket. Black to Black, White to

White, and Green to Green or Bare Wires.

• In line with the hanging board, drill 8 holes in the ceiling (see Figure 1).

• Using appropriate explode screws, attach the hanging board to the ceiling (see Figure 1).

• Calculate the total length of the angle iron

required so that the overlap angle iron is

no less than 100 mm (3.94 po) and that the

distance from the bottom of the range hood

and the cooking surface is between 61 to 76

cm (24 po to 30 po).

• Attach the 2 sections of the angle iron

together for each corner using supplied 16

pieces M4 × 10 mm mounting screws with

nuts and washers (see Figure 2).

• Use 8 pieces M4 × 10 mm mounting screws

to attach the angle iron into the hanging

board (see Figure 2).

STEP 6

Preparations

NOTE: To avoid damage to your hood, prevent debris from entering the vent opening.

NOTE: Use threaded drywall anchors only when mounting the hood on sheet rock. Mounting the hood on wall studs

or lumbers is highly recommended.

• Determine and mark the centre line on the ceiling where the range hood will be installed. A distance of 24 inches to 30

inches from the stove top is recommended, with a minimum of 30 inches for gas stove tops.

• Make sure there is proper clearance within the ceiling for exhaust vent.

• Duetotheweightandsizeofthisunit,pleasemakesurethatthesupportsystemorframeworkbeingusedisstableand

secure in the ceiling.

• Put a thick, protective covering over countertop, cooktop or range to protect from damage or dirt.

• Removeanyhazardousobjectsaroundtheareawheninstalling.

CAUTION

If moving the cooking range is necessary to install the hood, turn OFF the power on an electric range at the main

electrical box. SHUT OFF THE GAS BEFORE MOVING A GAS RANGE.

Figure 1 Figure 2

Installation

Loading ...

Ancona AN-1419 Noturna IG 36 in. Island Glass Range Hood in Stainless Steel