Loading ...
Loading ...
Loading ...
Rinnai 28 HW_CF OIM
Additional Programming & Activation Requirements
QUESTION
?
IF NO:
You have three (or fewer) water controllers, go to Question 2.
IF YES:
STEP 1:
(approximately 5 seconds).
STEP 2:
Check that the display on ALL FOUR water controllers is lit and displaying a
two dashes (see Fig. 2) repeat STEP 1.
This completes the activation procedure for the fourth water controller, you
may ignore Question 2.
QUESTION
?
IF YES:
No further action required..
IF NO:
You will need to program the kitchen water controller to enable selection of
temperatures higher than 50°C.
STEP 1:
(approximately 5 seconds).
STEP 2:
possible to select temperatures higher than 50°C. If not, repeat STEP 1.
NOTE
If the water controller in the kitchen is replaced, repeat STEP 1 for the replacement water
controller.
If the water controller in the kitchen is swapped with another water controller (for example, the
STEP 1 for the water controller moved from the
kitchen to the bathroom. Then perform STEP 1 for the water controller moved from bathroom
to the kitchen.
Fig. 1
Fig. 2
Fig. 3
Loading ...
Loading ...
Loading ...