Loading ...
Loading ...
Loading ...
Rinnai 20 HW_CF OIM
Horizontal Obstructions
and obstruction facing the terminal.
MUST ‘obstruct’
the full front cover height of the appliance (for appliance dimensions, refer to "Table 3. Appliance Dimensions -
IMPORTANT
There MUST be NO partial obstructions to the front cover of the appliance or any other parts
of the appliance casing. This will avoid the appliance failing to operate under windy conditions.
Sideways Flue Diverter - All models except REU-VCM
MUST also
WARNING
CONTROL BOARD DIPSWITCH SETTING (NOT REU-VCM):
The installer MUST follow the Sideways Flue Diverter instructions of the "Commissioning Check
List" provided on the front cover of the appliance and the "Commissioning Instructions" located
in the inside the appliance front cover.
When delivered ex-factory ALL the
switches of the control board dipswitch
are set to OFF (left position).
the installer MUST set switches SW1
and SW3 to ON (right position) ONLY.
Improper setting of the switches will cause the appliance to operate incorrectly.
Multiple Appliance Installations
of the same model are installed on the same vertical
Under these conditions appliances can abut each other
For appliance dimensions, refer to "Table 3. Appliance
Universal Water Controller" on page 34.
500mm
MINIMUM OBSTRUCTION
HEIGHT IS TO BE NO LESS
THAN TOP OF APPLIANCE
SW1 (OFF)
SW2 (OFF)
SW3 (OFF)
SW4 (OFF)
ON
DipSW
SW1 (ON)
SW2 (OFF)
SW3 (ON)
SW4 (OFF)
ON
DipSW
Factory Default Sideways Flue Diverter
Loading ...
Loading ...
Loading ...