Loading ...
Loading ...
Loading ...
RULES FOR SAFE OPERATION (Continued)
• Make sure cord is located so that itwill not be •
stepped on, tripped over, or otherwise subjected
to damage or stress.
• An extension cord should not be used unless
absolutely necessary. Use of improper
extension cord could result in a risk of fire and
electric shock, if extension cord must be used,
make sure:
a. That pins on plug of extension cord are the ,_
same number, size and shape as those of •
plug on charger.
b. That extension cord is properly wired and in
good electrical condition; and
c. That wire size is large enough for AC
ampere rating of charger as specified
below:
Cord Length (Feet) 25' 50' 100'
Cord Size (AWG) 16 16 16
Note: AWG = American Wire Gage •
• DO NOT OPERATE CHARGER WITH A
DAMAGED CORD OR PLUG. If damaged,
have replaced immediately by a qualified
serviceman.
• Do not operate charger if it has received a
sharp blow, been dropped, or otherwise •
damaged in any way; take it to a qualified
serviceman.
• Do not disassemble charger; take it to a
qualified serviceman when service or repair is
required. Incorrect reassembly may result in a
risk of electric shock or fire. •
• To reduce risk of electric shock, unplug charger
from outlet before attempting any maintenance
or cleaning. Turning off controls will net reduce •
this risk.
• Do not use charger outdoors.
• Disconnect charger from power supply when
not in use.
IMPORTANT SAFETY INSTRUCTIONS FOR
TRIM SAWS
KEEP GUARDS IN PLACE AND IN WORKING
ORDER. Never wedge or tie lower blade guard
open. Check operation of lower blade guard
before each use. Do not use if lower blade guard
does not close briskly over saw blade.
_, WARNING: If saw is dropped, lower blade
guard or bumper may be bent, restricting full
return. If lower blade guard or bumper becomes
bent or damaged, replace them before reuse.
KEEP BLADES CLEAN AND SHARP. Sharp
blades minimize stalling and kickback,
KEEP HANDS AWAY FROM CUTTING AREA.
Keep hands away from blade. Do not reach
underneath work while blade is rotating. Do not
attempt to remove cut material when blade is
moving.
WARNING: Blades coast after turn off.
USE RIP FENCE. Always use a fence or straight
edge guide when ripping.
SUPPORT LARGE PANELS. To minimize the
risk of blade pinching and kickback, always
support large panels as shown in Figure 11,
Page 12. When cutting operation requires the
resting of the saw on the workpiece, the saw
should be rested on the larger portion and the
smaller piece cut off.
LOWER BLADE GUARD.
WARNING: If lower blade guard must be raised
to make a cut, always raise it with the retracting
handle to avoid serious injury. See Figure 24,
Page 17.
GUARD AGAINST KICKBACK, Kickback occurs
when the saw stalls rapidly and is driven back
towards the operator. Release switch
immediately if blade binds or saw stalls. Don't
remove saw from work during a cut while the
blade is moving. See Pages 12 and 13.
BEFORE MAKING A CUT, BE SURE THE
DEPTH AND BEVEL ADJUSTMENTS ARE
TIGHT.
USE ONLY CORRECT BLADES. Do not use
blades with incorrect size holes. Never use blade
washers or bolts that are defective or incorrect.
The maximum blade capacity of your saw is 5-1/2
inches.
NEVER touch the blade or other moving parts
during use.
NEVER start a saw when its blade is touching
the workpiece.
NEVER lay a tool down before its moving parts
have come to a complete stop.
SAVE THESE INSTRUCTIONS. Refer to them
frequently and use them to instruct others who
may use this tool. If you loan someone this tool,
loan them these instructions also.
Loading ...
Loading ...
Loading ...