Loading ...
Loading ...
Loading ...
• Fitsawbladeinsidelowerbladeguardandonto
spindle.Note:Thesawteethpointupwardatthe
frontofsawasshowninfigure5.
• Replaceouterbladewasher.
• Depressspindlelockbutton,thenreplaceblade
screw."l]ghtenbladescrewsecurely.
Note:Turnbladescrewcounterclockwisetotighten.
• Returnbladewrenchtostoragearea.
REMEMBER: Never use a blade that is too thick to
allow the outer blade washer to engage with the
flats on the spindle.
TO REMOVE BLADE:
• Remove battery pack from saw.
,_ WARNING: Failure to remove battery pack from
saw could result in accidental starting causing
possible serious personal injury.
• Remove blade wrench from storage area.
See Figure 3.
• Position your saw as shown in figure 6, depress
spindle lock button, and remove blade screw.
Note: Turn blade screw clockwise to remove.
• Remove outer blade washer. See Figure 5.
Note: Blade can be removed at this point.
SPINDLE
LOCKBUTTON
BLADE
SCREW
\
BLADE
WRENCH
Fig. 6
SAW BLADES
The best of saw blades will not cut efficiently if they
are not kept clean, sharp, and properly set. Using a
dull blade will place a heavy load on your saw and
increase the danger of kickback. Keep extra blades on
hand, so that sharp blades are always available.
Gum and wood pitch hardened on blades will slow
your saw down. Use gum and pitch remover, hot
water, or kerosene to remove these accumulations. Do
not use gasoline.
BLADE GUARD SYSTEM
The lower blade guard attached to your trim saw is
there for your protection and safety. It should
never be altered for any reason. If it becomes
damaged or begins to return slow or sluggish, do
not operate your saw until the damage has been
repaired or replaced. Always leave guard in
operating position when using saw.
_1, DANGER: When sawing through workpiece,
lower blade guard does not cover blade on the
underside of workpiece. Since blade is exposed
on underside of workpiece, keep hands and
fingers away from cutting area. Any part of your
body coming in contact with moving blade will
result in serious injury. See Figure 7.
LOWERBLADEGUARD
ISINUP POSITION
WHENMAKINGA CUT
BLADEEXPOSEDON
UNDERSIDEOFWORKPIECE
Fig. 7
Never use saw when guard is not operating
correctly. Guard should be checked for correct
operation before each use. If you drop your saw,
check the lower blade guard and bumper for
damage at all depth settings before reuse. Note:
The guard is operating correctly when it moves
freely and readily returns to the closed position. If
for any reason your lower blade guard does not
close freely, take it to the nearest Sears Parts and
Repair Center for service before using.
11
Loading ...
Loading ...
Loading ...