Loading ...
Loading ...
Loading ...
• Whenmakingacutusesteady,evenpressure.
Neverforcecuts.
• Do not cut warped or wet lumber.
• Always hold your saw firmly with both hands and
keep your body in a balanced position so as to
resist the forces of kickback should it occur.
When using your saw, always stay alert and
exercise control. Do not remove your saw from
workpieoe while the blade is moving.
DEPTH OF CUT ADJUSTMENT
Always keep correct blade depth setting. The correct
blade depth setting for all cuts should not exceed 1/4
inch below the material to be cut. More blade depth
will increase the chance of kickback and cause the cut
to be rough. One blade tooth below the material to be
cut works best for most efficient cutting action.
TO ADJUST BLADE DEPTH
• Remove battery pack from saw.
,_ WARNING: Failure to remove battery pack from
saw could result in accidental starting causing
possible serious personal injury.
<nob.See Figure 12.
% DEPTH
BASE ADJUSTMENT
ASSEMBLY KNOB Fig. 12
• Hold base flat against the workpiece and raise or
lower saw until the required depth is reached.
• Tighten depth adjustment knob securely.
STARTING A CUT
Know the right way to use your saw.
See Figure 13.
RIGHT Fig. 13
Never use your saw as shown in figure 14.
WRONG
\
Fig. 14
Never place your hand on the workpiece behind
your saw while making a cut.
_1, WARNING: To make sawing easier and safer,
always maintain proper control of your saw. Loss
of control of your saw could cause an accident
resulting in possible serious injury.
13
Loading ...
Loading ...
Loading ...