Loading ...
Loading ...
Loading ...
15 — English
Fig. 6
OPERATION
When powered and connected to the mower, the LED
indicator on the charger will illuminate to indicate the
charger’s status. See the chart that follows to determine
the meaning of the LED’s display.
When you are ready to mow, disconnect the charger from
the power supply, then disconnect the charger from the
mower.
NOTICE:
Always turn power switch to OFF position and remove
key when charging mower and when mower is not in use.
NOTICE:
Always connect the mower to the charger when the unit
is not in use. If it is not possible to leave the mower char-
ger connected, make sure to charge the batteries fully at
least once a month.
LED INDICATOR
ON CHARGER
Fig. 5
CHARGER
PLUG
CHARGING
PORT
STATUS
CONNECT
AC
CONNECT
RECEPTACLE
CHARGER
GREEN LED
RECEPTACLE
GREEN LED
DESCRIPTION
Standby YES NO ON OFF
Charger may be connected to power supply
but not connected to mower.
Charging YES YES ON
SLOW FLASH
(500ms ON/500ms
OFF)
Charger is fully connected and mower bat-
teries are charging.
Charger Error YES YES OFF
FAST FLASH
(200ms ON/200ms
OFF)
Charger is connected to mower but is
not connected to power supply. Batteries
or charger are too hot or too cold. Once
normal temperature is reached, charging
will begin.
Fully Charged YES YES ON ON Batteries are fully charged.
Pack Defective YES YES ON
FAST FLASH
(200ms ON/200ms
OFF)
Batteries are deeply discharged. Once
voltage is reached, charging will begin. If
charging does not occur, the battery packs
could be defective.
If charger is connected to both power supply and mower, and an error condition exists. Disconnect charger from mower,
perform a suggested remedy below, then try charging again.
• Remove debris from charger/mower connection
• Allow hot batteries to cool
• Lower over voltage batteries by running the mower to discharge
• Verify mower battery series configuration is correct
• Clean charger cooling fins and if hot, allow to cool
Loading ...
Loading ...
Loading ...