Loading ...
Loading ...
Loading ...
DGX-670 Owner’s Manual
105
Troubleshooting
USB Audio Player/Recorder
A message indicating the drive is busy
appears, and the recording is aborted.
• Make sure to use a compatible USB flash drive (page 91).
• Make sure that the USB flash drive has enough memory (page 92).
• If you are using a USB flash drive to which data has already been
recorded, check first that no important data remains on the device, and
then format it (page 92) and try recording again.
Audio files cannot be selected. The file format may not be compatible with the instrument. The compatible
format is only WAV. The DRM protected files cannot be played back.
Recorded file is played back at a different
volume compared to when it was recorded.
The audio playback volume has been changed (page 74). Setting the
volume value to 100 plays back the file at the same volume as when it was
recorded.
Microphone
The microphone input signal cannot be
recorded.
The microphone input signal cannot be recorded as a Song (in MIDI
format). Record by using USB Audio Recorder (page 75).
Mixer
The sound seems strange or different than
expected when changing a rhythm Voice
(Drum kit, etc.) of the Style or Song from the
Mixer.
When changing the rhythm/percussion Voices (drum kits, etc.) of the Style
and Song, the detailed settings related to the drum voice are reset, and in
some cases you may be unable to restore the original sound. You can
restore the original sound by selecting the same Song or Style again.
Connection
The speakers do not switch off when a pair of
headphones is connected to the [PHONES/
OUTPUT] jack.
The Speaker setting is On. Set the speaker setting to Headphone Switch
via [MENU] Cursor buttons [U][D][L][R] Utility, [ENTER] TAB [L]
Config1 Cursor button [D] 1 Speaker. For details, refer to the Reference
Manual on the website, Chapter 10.
The on/off setting of the pedal connected to
the [AUX PEDAL] jack is reversed.
Change the polarity settings: [MENU] Cursor buttons [U][D][L][R]
Controller, [ENTER] TAB [R] Setting Cursor button [D] 3 AUX Pedal
Polarity. For details, refer to the Reference Manual on the website,
Chapter 9.
The Wireless LAN icon is not shown in the
Menu display even though the USB wireless
LAN adaptor is connected.
Disconnect the USB wireless LAN adaptor and connect it again.
The Bluetooth-equipped device cannot be
paired with nor connected to the instrument.
Check the Bluetooth function of the Bluetooth-equipped device is
activated. To connect the Bluetooth-equipped device and the instrument,
Bluetooth function of both devices need to be turned on.
• The Bluetooth-equipped device and the instrument need to be paired to
connect each other via Bluetooth (page 96).
• In case there is a device (microwave oven, wireless LAN device, etc.)
that outputs signals in the 2.4 GHz frequency band nearby, move this
instrument away from the device that is emitting radio-frequency
signals.
Sound input to the [AUX IN] jack is
interrupted.
The output volume of the external device connected to the [AUX IN] jack
of this instrument is too low. Increase the output volume of the external
device. The volume level reproduced via this instrument’s speakers can
be adjusted by using the [MASTER VOLUME] dial. The Noise Gate
function may be cutting the soft sounds. If this happens, turn off the
AUX In Noise Gate parameter (page 95).
Loading ...
Loading ...
Loading ...