Kenmore 10644103300 Cabinet Depth Side by Side Refrigerator

Use & Care Guide - Page 10

For 10644103300.

PDF File Manual, 64 pages, Read Online | Download pdf file

10644103300 photo
Loading ...
Loading ...
Loading ...
To dispense water.
1. Press a glass against the water dispenser lever.
IMPORTANT: You do not need to apply a lot of pressure to
the lever in order to activate the water dispenser. Pressing
harder will not make the water dispense faster.
2. Remove the glass to stop dispensing.
NOTE: Water may have an off-flavor if you do not use the
dispenser frequently. Dispense enough water every week to
maintain a fresh supply.
The Dispenser Light
When you use the dispenser, the lever will automatically turn the
light on. If you want the light to be on continuously, press the
LIGHT button.
®
ON: Press the light bulb symbol on the dispenser control panel to
turn the dispenser light on.
OFF: Press the light bulb symbol again to turn the dispenser light
off.
The control panel lights are LEDs which should not need to be
changed. If it appears that your control panel lights are not
working, check to be sure that the light sensor is not blocked.
The Dispenser Lock
The ice and water dispensers can be turned off for easy cleaning
or to prevent accidental dispensing by small children and pets.
Press and hold Dispenser Lockout for about 3 seconds to
turn off the dispensers. The lock symbol will light up (yellow
LED). The ice and water dispensers will not work.
Press and hold Dispenser Lockout for about 3 seconds to
reactivate the dispenser levers. The lock symbol (yellow LED)
will turn off. Then continue to dispense ice or water as usual.
DISPENSER
LOCKOUT
NOTE: The lock feature does not shut off power to the product,
to the ice maker, or to the dispenser light. It simply deactivates
the dispenser levers.
The Base Grille Water Filter Status Light
The water filter status light indicates when to change the water
filter cartridge. The light is located on the control panel above the
ice and water dispensers.
(_ GREEN= GOOD
YELLOW ORDER
RED= REPLACE
When the light changes from green to yellow, this means that it is
almost time to change the base grille water filter cartridge (90%
of the filter life has been used).
It is recommended that you replace the base grille water filter
cartridge when the water filter status light changes to red OR
when water flow to the water dispenser or ice maker decreases
noticeably. See "Changing the Base Grille Filter" later in this
section.
NOTE: Do not use with water that is microbiologically unsafe
or of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction may
be used on disinfected waters that may contain filterable
cysts.
After changing the base grille water filter cartridge, reset the
water filter status light by pressing and holding the RESET button
for 3 seconds. The indicator light will change from red to green
when the system is reset.
NOTE: It is possible to reset the water filter status only when the
indicator light is red.
Changing the Base Grille Filter
1. Locate the water filter cartridge cap in the front base grille.
Rotate the cap counterclockwise to a vertical position and
pull the cap and filter cartridge out through the base grille.
NOTE: There will be water in the cartridge. Some spilling may
OCCUR
2. Remove the cartridge cap by sliding it off the end of the old
cartridge. The cap will slide to the left or right. DO NOT
DISCARD THE CAR
3. Take the new cartridge out of its packaging and remove
protective cover from o-rings.
4. Slide the cartridge cap onto the new cartridge. See
illustration in Step 2.
5. With cartridge cap in the vertical position, push the new filter
cartridge into the base grille until it stops. Rotate the cartridge
cap clockwise to a horizontal position. Flush the water
system (see "Flushing the Water System After Replacing
Filter" section).
I
Flushing the Water System After Replacing Filter
Use a sturdy container to depress the water dispenser bar until
the water begins to flow. Flush the water system by dispensing
and discarding 2 to 3 gal. (8 to 12 L) of water. Cleaning the
system will take approximately 6 to 7 minutes and will help clear
air from the line. Additional flushing may be required in some
households.
NOTE: As air is cleared from the system, water may spurt out of
the dispenser.
10
Loading ...
Loading ...
Loading ...